Discussion Locked

NT 4.0 Video problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I recently installed a new NIC into a NT 4.0 Workstation and somehow during the process I now have a problem with my video. When I boot the system for the first time each day, the system comes up in the VGA mode. If I re-start the system, it thencomes up using teh correct video drivers for the card installed.
Any suggestions as to how to resolve this so that I don't have to re-start the system each time I turn it on??

5 replies

by parbo

It might sound silly but remove the current driver so othat it goes back to vga. reboot and reload the correct driver or an updated one.
I remember that applying the service pack would do this with older videocard, but I havent seen it lately.

by rlevesque

The one time I ran into this type of problem, was when I was using an AGP video card and put in a new pci NIC in the 1st slot. The board I was using, shared IRQ with the AGP slot and the 1st PCI slot. If your NIC is in the 1st PCI slot and you are using an AGP card, move the NIC to the next slot and try that.

Good luck

This discussion is closed to new replies.