13 replies
by willcomp
First see if it will boot and run in safe mode. If so, you likely have a driver issue.
If it will not run in safe mode, could be a hardware problem.
Add a comment to your question telling us what happens when you boot into safe mode.
Dalton
by willcomp
Runs in safe mode but not in normal mode usually means a corrupt driver. Pinning the culprit down is a trial and error process. The most common one is the video driver.
Change to PCI VGA adapter in safe mode and see what happens.
Here's a link I found that may assist you in changing video adapter settings.
http://www.mysuperpc.com/vcu/standard_vga_driver.shtml
Dalton
by willcomp
Disconnect all peripherals e.g. printers and USB devices. Remove add-in cards not required for bootup, only video is necessary. Disconnect power and signal cables from optical drives.
Try starting Windows with this minimal configuration and see what happens. At this point I suspect a hardware malfunction causing problems loading driver.
by razz2
This could also be a thermal issue with the power supply or another part over heating. Try the safe mode idea that was suggested to rule out a driver issue and maybe try opening the side of the case with the box in a well ventilated area and see if it stays on a bit longer. Check all of the fans to make sure they are spinning too.
Good Luck,
razz
by dmiles
by wlbowers
Boot to dos. See if the computer will stay running.
If it does not open the case and look at the fan on the cpu.
Dust build up will cause the fan not to draw the necessary air across the heatsink. Dust collected on the heatsink fins acts as a blanket and keeps heat in.
Use dry compressed air to blow the dust off. Use qtips if necessary.
Tech tip. Blow the case out outside. You will not believe the amount of dust that will come out.
Good Luck Lee
by kingson13
by kingson13
by razz2
If it boots in Safe Mode and stays on then the issue is not
hardware. It is most likely a Spy/Adware problem, or a virus/
trojan, or a driver.
So many choices eh? In msconfig on the startup tab what is
running that should not be? Try disabling all un-needed ones
and trying again in normal mode. Either way you need to check
for malware. I use more than one app as none find everything. I
use Adaware and Spybot S&D. Make sure to update the
definitions and have a copy of hijackthis on hand to check it's
log.
It is sad, but there are so many times I troubleshoot connectivity
issues or the like and now a days I can not troubleshoot
anything until I know the PC is clean of SPyware and Adware.
Once I trust it is clean then if the problem is still there I can
solve it. But, most the time the malware is the cause.
Good Luck,
razz
by kingson13
by kingson13
by prigal123
Plug off the power cable. open the cpu cabinet. remove the battery and have it aside for 30-45 seconds. then replace the battery or even a new battery would be fine. this should solve your problem as i have faced this problem and i did what i had mentioned.
Try your luck !!
by kingson13
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending