And any type of External Drive will cause this issue. The correct way to deal with a external Backup Drive is to only have it connected when it is needed and to use the Safely Remove Option on the Bar near the Clock to remove the drive when it is not being used.
All External Drives are destroyed by Heat and Vibration even a Solid State Drive and leaving them constantly connected generates a lot of heat not to mention when the computer is shut down it may occur that a write is happening to the HDD as the system turns off corrupting he Partition Tables, Master Boot Record or whatever you wish to call it rendering all Data on the drive lost.
I remember a case where someone plugged a external drive into a Server that was left running 24/7 and when I touched the casing I got a 3rd Deg Burn the case was so hot. The drive was failing and took the server along for the trip meaning that no one in that Surgery could access Patient Records. Not sure how long that drive was plugged in or what it was there for but it did cause quite a few issues when I discovered it as it wasn’t supposed to be there. It also wasn’t actively cooled so the heat kept building up till it destroyed the drive.
If you must have any external drive constantly connected you have to use a Actively Cooled Case like the Antec MX1 where you buy the enclosure and fit a SATA Drive to it. Can be connected with either a USB or ESATA Lead and the fan in the bottom of the case draws air over the installed HDD and keeps it cool. Ideally you should have it connected by the ESATA Lead not the USB lead if you are leaving it running all of the time.
If you buy a pre-made external drive which are considerably cheaper you need to understand that these are Temporary Usage and never designed for Full Time Usage and any Data stored on them can at best be considered as Temporary as the drive is going to die very quickly and quite likely in the time it is used loose all of the Data on it several Times before the drive dies.
These type of cases also have a On Off Switch which allows you to leave the drive constantly connected but only working when it’s needed so Booting problems do not arise.