7 replies
by jreyesz28 Accepted solution
by meridenscrafts Accepted solution
open up your computer, make sure you are well grounded. Check all the cards, memory,etc. to make sure all cards and memory are seeded in there slots. You may have bounced it around in the car and something came loose. especially your memory sticks. Check to see if it might be getting real hot somewhere. Switch box, video card. check to see if there is a lot of dust inside, may have gotten knocked down on something. Hope it helps
dust can get inside real easy.
by hal 9000 Accepted solution
If it's longer than 5 seconds or so this is what should be happening as you should only push on the Power Button to give a ripple on the powered on 5 V DC line to start the Power Supply running.
After the On Button has been held in for a certain amount of time the unit will be powered down this can happen when you release the On Button or prior to that depending on the hardware involved.
But if you have moved the unit open the case and look for a build up of dust and other rubbish inside the case and clean it out without using one of those Static Cleaners which will destroy the unit. I tend to use Compressed air to do this with but a vacuum cleaner will do as good a job.
Lately with a lot of rubbish being built up in cases I've been replacing quite a few Power Supplies because they are damaged by all this dust and other rubbish which causes shorts to occur so if the device is no longer working try a different Power Supply but first make sure that everything is properly connected as the trip could have caused some power connectors to work slightly loose and they are no longer making proper contact.
You should also check the RAM and any Plug In Cards which may have been moved slightly as well.
Col
by jreyesz28 Accepted solution
by sgt_shultz Accepted solution
just to keep from having to open the box, maybe just have a hard look make sure keyboard and mouse are in correct port, no bent pins. or low batteries in wireless etc.
watch screen very carefully at this partial boot. see if you can enter setup and study all the configuration options there that have to do with booting and hardware checking at boot time.
by jreyesz28 Accepted solution
by hal 9000 Accepted solution
This is a common issue and is easily fixed by replacing the coin Battery that should be a CR2023 or a replacement for that type of Lithium battery.
When you replace the battery you need to remember that the side with all the markings goes away from the M'Board. Now for the main problem do you have a USB Keyboard? If so grab a PS2 and use that to do the initial setup of BIOS after replacing the battery as the USB Drivers are not loaded till much latter in the boot sequence and you will be unable to enter BIOS and change the settings which should at the very least should be the Date & Time and whatever else you need changed things like the Boot Order come to mind and L2 Caching as well but this depends on the make of the M'Board as to what you'll need to change.
Col
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending