Discussion Locked

PC Troubleshooting--Compaq

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

All I did was attempt to swap hard drives in a Compaq Dekspro 2000. I unplugged the power cable and the IDE cables and reconnected them successfully. Now when I boot the PC, I keep getting an error:
1790--Disk error.
Can someone help me?

11 replies

by timwalsh

According to Compaq online support, your error message means "hard disk error or wrong drive type."
Was the second drive the same make and size as the first one?
If not, this error means that the computer doesn't recognize the new drive's parameters. You need to enter the System Configuration Utility (nomally accessed by hitting the Del key or a F-key at the initial boot up screen) to adjust the drive parameters to match the new drive. Usually this Utility will include an Auto-detect function so that you don't have to manually adjust the parameters.
Good Luck!

by Member 32254067

there are a couple of things that i would recomend. first off is the drive set as to the correct jumper setting? check that then swap the drive cables around to see if it gets picked up. i have come accross this issue with the deskpro 2000 series and have resolved it by either setting it the correct jumper setting or by switching ide's. give it a shot.

by sfc_gijoe

Was it a new hard drive you put in? Did you clone your old HD to the new HD? Here are a few things I would check:
1. Check the cable type you are using. 40pin/80wire UDMA cable or 40pin/40wire cable

2. Change the interface speed in the BIOS fromATA100 (UDMA5) to ATA66(UDMA4) or 33(UDMA2).

by bohicam1

You do not mention if this is drive with a bootable partition or not. If so, is the hard drive too large for the bios to accept? Is the machine older? In order to get into the cmos of a compaq, try hitting F10 at bootup.
Good luck!

Mike

by dcosgrove

this is a typical compaq bios message. You may be able to enter the bios a set this drive as your primary master. Some models are more complicated, and some restore disks wont work with different drive sizes than the original configuration.

This discussion is closed to new replies.