19 replies
by ped
if sounds like a irq problem.
have you tried pressing the f8 key to bootup in safe mode?
if that doesn't work then i would remove all device (ie. sound card, modem, nic, etc..) and only boot with the video card
if that work then i would add each device one at a time after rebooting each time.
if none of these work then check you bios.
by xaqfox
by xaqfox
by roland63
Assuming your pc meets WinME minimum system requirements, I'd say the next thing to do is remove everything from inside and leave only the HD, floppy drive, ram, and video card.
Reinstall ME and boot up from that point. Add additional toys (sound, modem, etc) one at the time REBOOTING between installs to make sure you tackle the problem as soon as you experiece the problem again.
Make sure you have the very latest drivers for all your toys before you begin this whole process.
Good luck.
by xaqfox
by roland63
If your pc detects your drives on bootup, you should still be able to get into your bios.
I have a suspicion the boot sequence is out of whack.
Check and make sure its set to A,C meaning check in the A drive first then the C (hard drive).
Good luck.
by xaqfox
by buffalodan
Willing to bet it is not a defective hardware problem, I will assume that this machine was working before WinME was installed.....
First, simplify simplify simplify
Reduce the installed hardware to it's simplest configuration.
If possible, verify that your hardware is compatible with WinME at:
"Windowsupdate.microsoft.com"
Verify that the harddrive is Virus free,
Avoid HDD Bios overlay utilities, such as MaxBlast or EZBios (these affect the boot sector)
Update the system board Bios if possible.
(Assuming you have verified that your bios supports WInME, not all bios does...)
The problem as described, indicates that something is interfering with the reading of the boot sector, WinME is far less tolerant than Win9x, thus greater attention needs to be paid to "Hardware,Firmware,Software" compatibility.
When all else fails, return the computer to it's last known good configuration, and when troubleshooting perplexing problems such as this, try to keep extensive notes of your progress.
Good Luck,
Dan
by xaqfox
by cdobbin
I am having the same problem with my PC at work, I know I have bad sectors on my drive and I beleive this to be the cause. I am getting the exact same symptom as you, cursor up in the top left corner.If I trun it off and on a few times it will eventually boot.
I would say you have a hardware problem with the drive or your partition and/or master boot record got corrupted somehow.
Are you able to boot off a floppy and access the drive, if so try running scandisk, maybe even run f-disk and viewthe partition information to make sure nothing hooky went on, you could also run fdisk /mbr to reinitialize the master boot record.
As the other posts said to, it could'nt hurt to run a virus scan but given that this happened after install I would be surprised if that was the problem.
Hope this helps.
by cdobbin
Woops, did'nt see your comment about not being able to boot off a floppy, if you have stripped this thing down to the bare bones and even went as far as replacing the mother board and still have the same problem chances are it has nothing to do withyour drive itself,disconnect it altogether(harddrive) and try the floppy. I would also look to the IDE cables and the floppy drive itself, if you used the original cables with the new mainboard I would try new ones.
Good luck!
by xaqfox
by jimjennings
by xaqfox
by pokester45
by xaqfox
by rolandf
by xaqfox
by xaqfox
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending