Discussion Locked

pc won't start unless power is cut

0 helpful
18 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
win xp sp2 machine with an asus a7s333 mobo (award bios) and an amd xp 2100+. after box is on awhile, when user reboots pc, it refuses to reboot unless the ac supply is pulled. after a minute or two, with ac restored, it will boot into the bios with a warning that the cpu speed is wrong (it's not). exiting bios leads to normal win reboot, then all is normal. power supply has been replaced with no joy. I'm outta ideas...

18 replies

by morocco_mole

user also says that if left alone after a failed reboot, the pc sounds like a car trying to start (chuff-chuff sound). also sometimes the pc will restart on its own after 30 minutes or so, but not always, if left alone.

once pc is sucessfully rebooted, all works normal until the next time a restart is needed.

by dmiles

It has been noted that AMD processors so run at a slower speed than actually stated,lower the cpu speed in bios or check motherboard web site or manual to see what the actual speed to run at.

The other problem sounds a little dramatic,but the user should pull the case open and listen to where the sound he describes is coming from ,could be wires or cable that is coming in contact with the cpu fan or a malfunctioning case fan.
If all else fails then system should be checked by a tech to see if porblems can be pin pointed.

by morocco_mole

the 2100+ runs at 1.73Mhz. the other choice given in the bios is 1.3Mhz, which when selected also crashes the boot. all fans etc are running properly. noise seems to come from the hard drive trying to spin up upon return of ac. same happens with a replacement boot drive.
thanks for your thoughts. post if you think of anything else.

by black panther

Try running sfc /scannow

check the event log for errors

Click start, run, type chkdsk /f /r then press enter, type Y to confirm for next boot, press enter and reboot.

Look for the latest drivers for your video adapter

by morocco_mole

no errors present after sfc check. nothing unusual in the event log. chkdsk shows no problems. newest vid drivers make no difference.
thanks for your thoughts. post if you think of anything else.

by sgt_shultz

that is a weird one. much as i love zebra hunting i agree sounds like a wire got caught in the fan or maybe you have intermittent procssor fan or something.
definitely get the cover off and see and smell inside...
or - get it exorcised?

by morocco_mole

I'm leaning toward exorcism at this point. fans are running ok. nothing in or near them. thanks for your thoughts. post if you think of anything else.

by thechas

I have seen similar behavior from a case or power supply fan plugged into the motherboard.

Some of these fans, and some CPU fans generate too much electrical noise and cause problems for the system board.

In light of the chug chug sound, it is VERY possible that a fan is starting to fail.
Or, as posted in another answer has a cable or wire that gets caught in the fan blades.

I do agree with the suggestion to verify that the CPU speed is set correctly.
However, on more than 1 motherboard with Athlon class CPUs, the speed that the BIOS considers to be the correct speed does not match the settings as recommended by AMD.

Part of this is that some BIOSes use actual clock speeds and others use AMDs performance speed when setting the CPU clock.

Let the BIOS set the CPU speed to what it thinks is correct in the CPU setup section.

Chas

by morocco_mole

pc has been running fine with the current compliment of fans, drives, processor, etc for a couple of years. sound seems to be from the hard drive trying to spin up upon reapplication of power. happens with new replacement drive as well. as mentioned above, either of the two clock speed choices in the bios result in the same problem, whether I choose it or the bios does. thanks for your thoughts. post if you think of anything else.

by morocco_mole

whoops. in one of my answers below I said the cpu runs at 1.73 Mhz and he other choice in the bios is 1.3 Mhz. both of those should read GHZ. what a mess...

by thechas

If I understand things correctly now, the hard drive starts to spin up, stops and then starts up again?

If so, the problem is either the power supply, or the power control circuit on the motherboard.

In an ATX system, the motherboard has circuits that tell the power supply to turn off or turn on.

The front panel power button just signals the power control circuit to change state.

I would swap in a new power supply.

If that does not take care of the problem, then the motherboard is the prime suspect.

I would still check ALL fans.

With power off, check for both bearing play (wobble) and how freely the fan spins.

If the fan blades can move either up and down, or side to side, the bearings are worn out and the fan needs to be replaced.

If the fan does not spin freely by hand, the lubrication has failed. It is still better to replace rather than attempt to salvage the fan.

Another possibility is a bad front panel power switch.

Chas

by hal 9000

I've just got a replacement M'Board of the same make and Model supplied after a similar restart problem with a 2100 AMD. As the PS was changed before I got my hands on the thing I'm unsure if that was a contributing factor, but the M'Board was defiantly the problem once I got my hands on it.

The owner used it until it drive her nuts which was quite a long time and eventually after about 20 restarts the M'Board failed completely so it was just a simple RMA as ASUS give a 3 year Warranty on these. When i reset the M'Board BIOS I had to setup the CPU manually as the FSB and Multiplier where both wrong according to the Auto Setup in BIOS if I remember correctly I think that the M'Board Manual tells you to do this as well of course I didn't bother to read it until things had gone too far and I'd wasted a lot of time. ;)

But if the HDD is making nasty noises the PS would be the first on my list to change out as well.

I hope that is of some help.

Col

by mjd420nova

Replace the mother board. The DMA controler
chip failed and is holding off the hard drive
and not allowing proper restart onless cold
boot. Its clue was in the failed BIOS that
was missinterprepting the bus fault the DMAchip
was causing.

by defiant

Check your motherboard's capasitors, they may be leaking or fried. Also try a BIOS flash, it will update your computer's BIOS. Go to awards website and look to see if a BIOS update is available, also try ASUS's website for a BIOS flash. I had a similar problem with my computer and flashing the BIOS fixed the problem. After you flash the BIOS you will need to reset your CMOS settings before the computer restarts. Yu will get a beeping sound and think that your computer is broken if you don't (I did).

Beyond that get all of your hardware tested, i.e. Ultimate Boot Cd or something, if the power supply was the problem it may have blown your memory or your MOBO or any other hardware. I have had a power supply go out and when replaced the computer would randomly restart, because the memory was blown. If you aren't already using a battery back-up I would suggest that you get one. This will prevent furture problems with power.

by willcomp

A few simple things to try. I would not waste too much more time on this one if quick and dirty doesn't work. I suspect you have a weak or failing capacitor in voltage regulation circuit on mobo. Replacing mobo is only recourse in that case unless you want to replace caps.

Change battery on mobo (can cause strange problems)

Flash BIOS

Leave HDD connected, disconnect other drives (both signal and power), and remove unneeded cards. Then see if problem is still present.

Have fun!

Dalton

by hackersforum

Well first of all the noise from the spinning of HDD is not a problem ( as now the speed of the HDD is very high ie min 7200 rpms).....

Well i think the problem is that the fan or the heat sink of the CPU is not working properly. As, a result of which it gets over heated and restarts automaticaly. Also, once restarted the BIOS initialization checks for the CPU temperature. If its high it does not start.(say 2 or 3 mins to cool)
Cheers!

by moondoggie53

I would check the power supply first. If you trust a particular person with your PC, they can run a test, but I would bet my own money on the power supply.

by aaron a baker

It may seem silly, but have you checked to make sure that your Output Transformer Fan is actually working? If not it will run for a while but then might be to hot to allow a restart.
Hence the cooldown time.Naturally this will cause your Bios to default and even misinterpret.

As for the Cpu it could just be a setup adjustment problem,.
I have a ASUS A7V880 with a 2.8 Gb CPU and 2G DDR Ram
I would always get a false reading until I went into the Bios and changed a few things.

First I went to the ADVANCED tab and the CHIPSET
Once in there, the default may be 444Mgz, I set it to 333Mgrz.
Then I changed my Dual Channel to a Single Channel.

Back at the Advance Menu I then went to JUMPER FREE area.
I set my CPU Multiplier to X12 instead of auto.
It might also be a good idea to check the Core voltage while you're there.
This helped me out very well.
Good Luck
Hope this has been of some help Regards
Aaron

This discussion is closed to new replies.