19 replies
by pantera4life00 Accepted solution
by xt john Accepted solution
by pantera4life00 Accepted solution
by xt john Accepted solution
by hal 9000 Accepted solution
And get a lot of spikes and other rubbish over the mains. The spikes effectively scramble the M'Board CPU and the only solution is to unplug and then plug back in. Though this generally affects things like Cable/ADSL Modems and Hubs first it can happen to a computer.
The fix here is to fit a UPS in line to prevent the Spikes getting through and causing the problem.
Col
by notmuch005 Accepted solution
by oh smeg Accepted solution
How do you jump something you short out the pins involved just like the On switch does in this case.
Personally I don't think that this will work because all you are doing is replicating the On Switch but if the switch is broken it will work.
Col
by pantera4life00 Accepted solution
But what do I know! I replaced the case once already and find it hard to believe that the switch was defective in both cases (As cheap as it was - PowerUp = Junk). After changing the power supply as well I figured it was a power issue. The pc is connected to what looks like a pretty old surge protector. This is my fathers pc. I had to build it with a $400 budget. I dont think he'll be willing to dump money into a UPS. Is it necessary or could a good surge protector take care of the problem?
This is the one I have laying around that I was going to replace it with:
http://www.lowes.com/lowes/lkn?action=productDetail&productId=114718-16503-PB004125&lpage=none
by hal 9000 Accepted solution
The better ones will divert a surge in around 4 Nanoseconds but the damage is done in under the first nanosecond. I've seen people spend hundreds of $ to fit a surge protector and still have no benefit when a $60.00 AU UPS would have done just as good a job. Though to be fair these cheap UPS's don't have great batteries in them and you may be required to replace the Batteries sooner rather than latter.
Col
by pantera4life00 Accepted solution
I found out today that the surge protector he's using is 10 years old. I purchased a tester from a hardware store that you plug into the wall and it indicates if the wiring is correct and properly grounded. He's not insterested in a UPS because he doesn't want to worry about replacing batteries. I'm going to make sure the outlet is wired correctly and might get a surge protector I was reading about on some audiophile website. They're supposed to beat any surge protector/power conditioner on the market and last forever. Price isn't too bad I guess. Here's their site:
http://brickwall.com/prodstds.htm
There has to be cheaper ones though that use the same technology.
by maillists Accepted solution
Or why you should use an UPS.
MOST surge suppresor/protectors turn into
extension cords after their first hit. And
no, the Wiring Fault indicator will not
indicate a Surge suppresors ability to
suppress surges. And surge suppresors do
NOT protect against brownouts, which tend
to cause more damage to computers than
surges due to the fact that MOST people do
not have an UPS, and most residential areas
require an UPS, and at least half of the
business areas do. (Especially since there
is no Federal building code for Electrical
wiring, or strict enough code to make the
Service providers of Electricity provide
QOS.)
Some real life examples: Mom's OLD house:
Went through 3 computers in one year. Put
in an UPS, went through 3 sets of batteries
in one year, but that still cost less than
one computer. (if you are chewing up
batteries even in a cheap UPS it's an
indication of possible fire hazards lurking
in your walls.)
Mom's NEW house: Went through 6 battery
sets in first year. Still waiting for the
contractor to come out and fix the wiring
issue. KNOW for a fact there is a wiring
issue as the SMOKE detectors also have
wiring fault indicators in them, and they
go off once a month because of it. (Alarm
is different for
smoke/fire/CarbonMonoxide/electrical)
In the meantime, it has been a lot less
expensive for us over all to keep replacing
UPS batteries, than spending time hunting
down issues like the one you
described...which by the way is indicative
that yes the switch IS now failing...and
you may want to put a POST code tester in
that machine if other wierd things happen.
Also...if the humidity is drier once a week
than other days...Static electricity will
build up in the Power Circuit to the
computer and prevent the completion of the
circuit. Sometimes unplugging the computer
fixes this, but usually it requires one
power the machine on and off several times
with it unplugged. (Toggle the power
switch.)
My vote is for the Humidity factor, as
sometimes that will always be the problem,
and it just takes that long to build up
enough static electricity to cause the
symptom. But my recommendation is still get
an UPS if you value the data on the machine
at all.
by hal 9000 Accepted solution
I have a Professional one wired into my Fuse Box cost at trade came to about $1,000.00 AU plus fitting. Granted I don't pay the sparky to fit the things but it still needs to be fitted correctly and then it only protects 1 Circuit.
Granted this unit is claimed to prevent any damage from a lighting strike at 100 meters. Well as I always unplug my Hardware when there are thunder storms this really isn't an issue but I like the added protection. The first year I went through 3 of these units and every one had taken a hit and done their job so they where no longer working and where effectively nothing more than a straight through Mains Power Supply. Still with that many destroyed the cost in replacing them was less than the cost of 1 computer.
These have now been in place since 1998 and I've had 25 of them destroyed so far and they keep getting replaced and the dead ones get checked to see what has happened to them 1 was replaced UG over all that time the rest have absorbed Lighting Strikes and done their job which is one use thing.
The UPS's that I use are the big expensive ones that run on 24 V DC so they are not the cheapest available. Since I've been using these over a protracted period of time I've had to replace 1 set of batteries per UPS since the initial Surge Protector went in place and at $65.00 AU Per Battery they are defiantly a lot cheaper than 1 Surge Protector even if I replace every battery in the place at one time they still wouldn't come to half the cost of 1 Surge Protector.
As for a static build up while the Mains Wiring may be correct are you sure that you have a good earth? Do you go out at least once a month and pour salt water around the earth spike? If not then the Earth that is available is questionable and any surge Protector will be unable to dump an excess charge to earth reliably.
The UPS's that I use not only filter the mains but LAN and Telephone lines as well so they do much more than just one job but even still I remove the Telephone lines from them when there is a thunder storm around. I would much rather spend a little bit of time in prevention than cleaning up destroyed high end workstations after the event.
As stated Surge Protectors do absolutely nothing to protect when Brown Outs occur and this is quite common when there is a Power Outage. When the system auto switches back on there is a massive spike followed by a drop of up to 70% of the mains Voltage and then it trips again. At this point in time there is a lot of potential to destroy computers and other electrical equipment.Particularly things with running motors in them and Switch Mode Power Supplies so Computers DVD Players, Video Recorders TV are all susceptible to destruction or at the very least damage which isn't covered by most Fusion Insurance Policies as they only cover Electric Motors and not electronics. Unless of course there has been specific mention made of this type of coverage with an increase in premiums.
I should add that the Surge Protector that you listed are similar to the ones that I use but the ones that I use have a higher rating and offer better protection in an over voltage event however they do nothing in an under voltage event which can be very common if you are toward the end of a mains power line and have things like AC Units and Swimming Pool Pumps switching on at the same time when this happens you are in a Brown Out Situation on a regular basis which has a cumulative effect rather than just a repair after the event with no real damage done.
Col
by pantera4life00 Accepted solution
by hal 9000 Accepted solution
A 10 year old computer has a XT Power Supply which actually switches on the Mains with a Single Throw Dual Pole Switch so it is either off or on.
An ATX power Supply which has been in use for quite some time but not as long as 10 years doesn't have a Mains Switch but switches on the 5 V DC Rail which is always on and there is always power to the M'Board while it is plugged in.
So you are comparing something that switches Off completely to something that puts the system into a Suspend Mode.
So use the new Surge Protector, Power Supply and see what happens. I would bet nothing different to what has been happening previously but try it none the less.
As for the basic UPS's I can buy then for about $50.00 AU so in the US they should be cheaper and they do protect against Brown Outs as they have Mains In that gets turned into a 12 V DC and then from the 12 V DC Battery there is an Inverted that supplies a Sine Wave type Power to the computer at your current Mains Voltage so there is no Under Voltage Events happening.
As for resetting the PS that's not quite right as the M'Board gets a scrambled message and throws in the towel, when this happens you need to disconnect the Mains Lead let the Capacitors Discharge and then plug it back in which is I believe what you have been doing isn't it?
But the only way to be sure is to suck it and see so run with the stuff that they have and see if there is any difference. If not then they will have to either start to unplug when not in use or put a UPS in line either way will work though unplugging will be much cheaper.
Col
by pantera4life00 Accepted solution
by jmgarvin Accepted solution
by pantera4life00 Accepted solution
I built it myself for him. The case was bundled with the mobo. Cheap. I already replaced the power supply that was in the case. Same problem. He took the switch out the other day and said it was a plastic piece of junk.
MB: Abit IG-80: http://www.abit-usa.com/products/mb/utility.php?categories=1&model=218
Case: PowerUp 2526 Mid-Tower
http://www.amazon.com/Power-Mid-Tower-Clear-450-Watt-Supply/dp/tech-data/B000NGIDG4/ref=de_a_smtd/104-6367932-9443108
Updated Power Supply: Ultra XVS 600-Watt ATX
http://www.ultraproducts.com/product_details.php?cPath=52&pPath=510&productID=512
by jcdshs Accepted solution
by cbg2 Accepted solution
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending