Discussion Locked

PC100 Memory

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Upgrade

I have a UMAX AMD-333 computer with the Biostar M5ALA motherboard with only 2 Dimm slots. Original memory was 2-32 meg PC66 chips. I replaced these with 2-66 meg PC100 chips. According to UMAX Tech and Biostar tech this should be a no problem. My software ACAD, MS Office, Paint Programs, etc, wont run. Tons of errors and lockups.

Also I plan to upgrade the CPU to a K6-2-500. Recently with the many thanks to the Biostar tech support staff, I was able to upgrade the bios (Required for the CPU). But no luck with the chips.

Can I swap the memory chips without the cpu? Or does the upgraded cpu affect the memory? Please Help, Help, Help?

I would appreciated any help. Thank You

Mitchell J. Sklar, P.E.
msklar@osassoc.com

9 replies

by dmiles

There is some effect,yet the PC-100 should work with the present BIOS,but you will have to open the CMOS control panel and reset your settings to regiter the memory,Depending on your OS use F2 or DELETE at startup and the control panel will open,then locate the memory settings and make changes.

by radovan

There is single solution but not good for you.
This MB is 66Mhz board and it will work only with 66Mhz RAM.
There is also other problem some MB-s will not work with single side RAM modules
Obtain PC-66 doubleside DIM memory

by b.snel

Hi Mitchell!

Faster chips require tighter timing. If you upgrade memory from PC-66 to PC-100 you also might need to change a jumper setting. The memory timing equals the bus tming. I Don't know the Biostar mainboard, but it's quite likely that this needs to be done. There should be an option either in the BIOS setup program or by setting a jumper that your bus clock isn't 66 MHz but 100 MHz...

Also it is possible that either the memory isn't seated correctly in the banks or that either the memory bank or chips are defective...

by bv2

Assuming the memory is good, try changing the speed settings for the memory to HST-CLK or 66 - I think the BioStar boards have the actual frequency. Either way, there should be some setting that will allow you to choose the frequency of the memory.

This discussion is closed to new replies.