Question Locked

PCI express card not seen on system with onboard video

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I recently bought an ATI Radeon X1300 Pro PCI-e card and installed it in a Dell E520. The Dell has an onboard video card that works, but this is supposed to be automatically overridden when the PCI-e card is inserted. The new card powers up but there is no video coming from it and the driver installation app doesn't see the card at all. I am using Windows Vista, anyone have anything I can try? I have scoured the BIOS settings to no avail.

10 replies

by craig herberg

Typically, you have to disable the onboard video to use another video card. If you can't find the onboard video setting in the BIOS, you may want to check the Dell web site. Are you sure the ATI card is compatible with your computer/OS combination?

Good luck.

Craig Herberg
http://info-safety.com

by mkrady

Dell sells the system - same computer - with that card, that's why I bought that one specifically.

by sgovin2

Hi

I have the same problem. I got a Radeon X1300 SFF PCI card for my Dell Optipelx GX260. I am not able to get any signal from the new card. The original onboard card works fine. I am not able to set the default in BIOS as it just has AUTO and OnBOARD option. Also, I use a LINUX machine.

So kindly reply if you found a solution.

Suresh

by paul.walker

I just got off the phone with their tech support and found out that the card needs a minimum of a 420 watt power supply. The HP D530 comes with a 240 watt max power supply, which is not enough for it to work.

by luisjr02

I am attempting to install the same type video card on a GX260. It has a 600 Watt power supply and I am having the same issues.

by luisjr02

I am attempting to install the same type video card on a GX260. It has a 600 Watt power supply and I am having the same issues.

by luisjr02

I am attempting to install the same type video card on a GX260. It has a 600 Watt power supply and I am having the same issues.

by luisjr02

I installed an older 64mb AGP card in conjuction with the PCI card. Because the bios only has two modes to its video (Onboard,Auto). The AGP card effectively disables the on board video, thus allowing the system to boot into the OS. Once this is done you will see that you will be able to add the PCI card. However there is one caveat, if you remove the AGP card after you have loaded the PCI card the system will re-enable the onboard video and you will be back to square one. Leaving the AGP card installed will not cause any issues, in fact it leaves you an option for running an additional monitor.

by edmundjeevan

I am in the same situation now. Unfortunately i dont have AGP slot in my Gigabyte motherboard.

This discussion is closed to new replies.