20 replies
by thechas
The 810 chip-set is for Celeron and PIII CPUs.
These usually did NOT have the axillary power connector.
Is this a "new" system?
Or one that stopped working 1 day?
For a new system:
Check and verify ALL connections.
Don't guess. If you cannot identify a connector ask us.
Check the position of the CMOS reset jumper.
Motherboards often ship with the jumper set to reset. In the reset position, most boards will not boot.
You can test an ATX power switch with an ohm-meter.
The 2 wires on the connector should read open with the switch just setting there.
When you press the button, the reading should be close to zero ohms.
If this was a working system that just stopped one day:
Remove any modem and NIC cards.
Check the motherboard for any sign of a burnt discolored or bulged component.
Try resetting the CMOS memory and see if it will now boot.
Chas
by nu4ever
Poster rated this answer.
by nu4ever
Chas this is an older system that we have used in the past. On Friday we moved the computer and on Monday when they tried to start it, it wouldn't start. I checked all the connections from the power supply and they all looked fine. I've been certified in A+ but am not sure where the cmos jumper reset is. As for removing the modem or NIC card if it boots up later do I reinstall them? Some the ideas you are giving me are new. With the ohm-meter I'm not sure where to put it. How do I reset the CMOS memory (do I just remove the battery) if so I did that already?
Waiting your reply
by hereinoz
Do the lights come on but it fails to boot up? Or do you get absolutely nothing, no lights, no fans, nothing?
If you get lights and fans, but no boot up, try re-seating the video card, particularly if it is an AGP card. If you have moved the machine, there is a possibility that this card has moved in its slot enough to cause a problem, and the problem is usually that the thing won't boot. AGP cards are like that.
Alan
by nu4ever
Poster rated this answer.
by nu4ever
by kathyjp
by nu4ever
Poster rated this answer.
by kathyjp
http://support.intel.com/support/motherboards/desktop/ca810e/ca2_con.htm
here is a pix of the MB front panel connectors.
by nu4ever
Poster rated this answer.
by nu4ever
by joortman
by nu4ever
Poster rated this answer.
by kathyjp
by nu4ever
Poster rated this answer.
by superman79
Ok just to make sure, I know this sounds kinda silly since it might be the least of the problem, have you check your outlet to see if its ok? or your UPS unit if you have one? move the comp back to where it was and see if it does the same thing.
You never know it might be the simplest things that dont work that make it the hardest to solve
by nu4ever
Poster rated this answer.
by nu4ever
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending