Discussion Locked

Printer problem - Win 95

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an older Pentium that is connected to an HP IIP printer. It will print from DOS edit command, but not once it gets into Windows 95. I have reinstalled the driver, I have checked the port with a Microscope (diagnostic software), but it just keeps timing out. Printer is online, but never starts accepting data. Help!

5 replies

by stephen

1st. Make sure you have the right hardware. I imagine since it prints in DOS, the cable is okay.
2nd. Make sure the port type in Device Manager is the right one (try ECP)... look in your BIOS for ECP,select it, reboot. Win95 should find the port and install it. Check the Device Manager first, remove the port if you need to, change the port type and reboot.
That should fix it.
Remember that you can always change the spool settings once Windows95 finds it.
Stephen
It really sounds like a physical problem.. cable, I/O port on the controller...

by paulp

I think by default, WIN95 sets up the parallel port as and ECP Printer port. Because your HP IIP is an older printer, it probably is being confused by the ECP Printer settings. I recommend you try setting the parallel port to "Printer Port" so that it acts as a plain old parallel port.
You may need your Windows95 CD to do this.
In Device Manager, click PORTS. If you see one labeled ECP Printer Port, highlight it and click PROPERTIES. Click DRIVER tab, click UPDATE DRIVER, click NO, click NEXT, click SHOW ALL HARDWARE, select PRINTER PORT, click FINISH. This is where you may need the WIN95 CD.

This discussion is closed to new replies.