Discussion Locked

Problem installing new video card

0 helpful
14 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Compaq SFF Deskpro EN (ENS/P866/15e/6/128c US) system with a integrated Intel 3D DVM video. I am trying to install a new Sapphire Radeon 9200se PCI video card, but after installing and rebooting the PC will not boot up, not even to BIOS setup.
Its running WXP SP2, I have tried uninstalling the Intel s/w and still wont recognize the card.
Have also tried disabling the device, but still freezes up on boot.
What am I missing????
Jerry

14 replies

by douglasb

I would try going into BIOS and loading "Fail Safe" or "Default" settings for the mother board. Either the new video card is causing a dead short (bad card) or the is an IRQ problem. I would doubt the IRQ because you should get an error message on that.

by pierrejamme

This footnot at the bottom of the Sapphire web site concerns me:
"General Card Specifications are subject to change dependent upon region purchased in and subject to component availability. Sapphire has enjoyed a commitment to excellence and to its customers so please do not hesitate to inquire about specific products at your regional Sapphire office"

I have had problems with the voltage not matching between what the motherboard required and what the video card required. I would check specifications on both to assure they are the same.
Just a thought

by jburke1

Scary thought...
Im checking with Compaq now and if it can even be upgraded...
Thanks for the input

by willcomp

Check BIOS settings for something like Boot PCI Video First or Boot AGP Video First. If possible, change BIOS setting to boot from PCI first.

Dalton

by dmiles

Boot the computer into Safe Mode, uninstall all software pertaining to graphisc card

Open Device Manager,check for any instances of the Display Graphics card,if so Remove

Rebbot computer and press the designated key to Bios setup,locate the on board graphics and make sure that it's disabled

Open case and reseat the Card in AGP slot,then proceed to install card,the card may have co0nflict that is causing it to hang make sure you have the updated software drivers

by 1stladytech

You may try installing the card with a larger powersupply hooked up externally. Some of those machines don't have enough power supply to run the new cards. Not sure that you can change the ps to a larger one, but it may answer the question of why it isn't going in.

Good luck,

Vickie

by jburke1

Im checking with Compaq now and if it can even be upgraded...
Thanks for the input

by blackcurrant

Hi

A friend of mine had a Dell machine with on-board graphics. He wanted to upgrade to a better graphics card so he could play the more demanding (and therefore, more fun) games.

We installed the new card (also a PCI) and the machine would not boot at all - just as you are describing. Removing the card allowed the machine to boot once more. After taking it to a repair shop (who could not install the card either), he rang Dell and was told that the machine was not designed to be upgraded.

Is this the case with yours also?

Good luck

by jburke1

Im checking with Compaq now and if it can even be upgraded...
Thanks for the input

by bwells47

Uninstall all video drivers. After shutting down, physically pull the video card, replace it, then reboot. Let the driver install as just a plain vga driver. Then go to settings, advanced, adapter, and click on "change". Click on "add new hardware." Follow the directions, untill you get to the part where you pick the device, and put, "have disk". with your disk in the drive, point the computer to the right path, and install your drivers. Reboot. Good luck bev

by carlos.nino

Are you sure there is no option in the BIOS to disable the integrated graphics card?. Even in the advanced options?

This discussion is closed to new replies.