Question Locked

Raid reset

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a computer with a xeon processor and a raid 1 set up with 40g hard drives. I have two new 500g wd5000ys re2 hard drives to install in place of the 40's, but want to reset to a raid 0 array. What is the procedure for the array change and what are the pin settings for each of the drives in this type arrangement?

2 replies

by Former member

The Sata Raid drives do not have pins on them like "Ide" drives because they are on different ports on the motherboard. To do a reset (Change) you will need to look at your screen and you will be able to see the "Sata Raid" bios section, this sometimes flashes past pretty quick so be ready to press either keys of which should be shown i:e F4 or F10 depending on what kind of motherboard "bios" software you have. When you have succeded in opening the raid section you will be able to select either "Raid 0 or Raid 1" this will also depends on which kind of "bios" you have installed. If you do not have the raid 0 or raid 1 then please go to the motherboard web site to down load and "flash" the "bios". You will need to be careful when you Flash the bios because if it is not done right you could end up with a non-bootable computer.
I hope this helps you, please post back with any more enquiries.

This discussion is closed to new replies.