Discussion Locked

Ram Problems

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a PenII 233mhz computer with 2 4mb and 2 8mb simms installed. I recently acquired 2 32mb simms but when I installed them, the computer won't boot up. The book on the motherboard says it will accept BEDO, EDO and Fast Page Mode simms up to 384mb's. Why can't I get these simms to work? The motherboard is a T16NFK/KP6. Is there a setting I should change in the system setup?

3 replies

by thechas

Have you tried it with just the 2 new simms?

While you can use various types of SIMMs, most systems require that all SIMMs be of the same type.

I would place the 2 new SIMMs in banks 0/1.

Also, make sure that the SIMMs are seated in the sockets. Both ends must be locked into the clips on the socket.

Another thing to check is that the sockets and the SIMMs have the same plating. (tin or gold) many systems would not work with mixed plating.

If your old memory modules had differentplating than the sockets, there may be corrosion on the socket pins that is preventing the new SIMMs from making contact.

If the contacts in the socket look tarnished or correded, GENTLY clean them with a white or pink pencil eraser.

Does the system work if you put the old memory back in?

If so, it is possible that one or both new SIMMs are bad.

If not, check for a jumper or cable that might have been disturbed when you installed the new SIMMs.
Sometimes, it doesn't take much to loosen a cable just enough to prevent the system from booting.

This discussion is closed to new replies.