Discussion Locked

RAM Upgrade

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am attempting to upgrade RAM on a computer for which I have no motherboard documentation. The RAM I purchased was PC-100 DIMM 32MB. The machine is a rather old Dell Dimension M166a. There are two DIMM slots, one is already filled with a pre-existing 32MB DIMM. When I install the new DIMM into the other slot only 8MB (Total 40)is detected. I then removed the old DIMM and put a second new one in and it detected just 16MB. Therefore only 8MB of the new stuff is showing up. Is my machine expecting something other than SDRAM? Are SDRAM and possibly EDO RAM compatible?

dksj

6 replies

by rockyolson

Hi well your mobo is limited to only 64 mg's so you can only use at most 2-32mg's. The only way to get more then that is a new mobo. rockyolson@chater.net

by dmiles

You will need to update the bios first and you can get the info from the start screen in the bottom left corner,then you want to boot the system into the CMOS Control Panel and change the setting of the Bios to detect more memory.
It may work and then it may not you are using PC100 DIMM and the 166 is on a 33mhz Bus,so the RAM upgrade may be uncompatible for your system

by dksj

Found out from PNY tech support that the type of RAM used for this computer is unusual, (has an unusual addressing scheme) and is incompatible with standard SDRAM. I was able to find the correct RAM at crucial.com.

Thanks

dksj

by bock2000

We have several of the same type of machines. We found that it takes a special type of DIMM to work properly, if not used flaky things can happen. My suggestion is to contact Dell. There website is www.dell.com

This discussion is closed to new replies.