Discussion Locked

ReadProcessMemory or WriteProcessMemory

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

hello all.

i've just built a new pc for a mate. while attempting to install software i got the following error message:

Only part of a ReadProcessMemory or WriteProcessMemory request was completed.

while i am still able to read the cd/view its contents, i am unable to run any .exe files. i've upgraded the firmware on the drive, triple checked the jumper settings.

system is WINXP updated with SP2 last night. SP2 made no difference.

after searching thru some forums i've found there are a fair few people that have experienced this prob but no one knows how to fix it!

If anyone can help it would be much appreciated!

Adz

2 replies

by machinegun_kelly

Is this a new CD-RW? If so, take it back. It looks a problem with the laser, maybe calaberation errors perhaps. Anyhow, if winXP is detecting the CD-RW then the problem is in the driver itself. If its not detected in winXP, you'll need to try a new cable and try all IDE ports on the motherboard. NOTE: SHUT OFF puter when unpluging or pluging anything into it. Unless its hot-swapable ofcourse.
When all else fails, when in doubt swap it out!

by meyster

Possible solution: (worked for me)

I have an HP DVD Writer 630i and was have the same issue.

HP tech support had me do the following. Go to the device manager->IDE ATA/ATAPI controllers. On the secondary driver, right click and go to properties. In this window go to the advanced settings tab. For "transfer mode" select PIO only.

Not sure why this works, but it did for me. I'm able to burn all files again, and read all exe and autorun files. Good luck.

This discussion is closed to new replies.