Discussion Locked

Regarding Connecting Of Two Harddisk

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

I am having one problem.I have two Harddisk and two cdrom.I connected but it's showing me one harddisk and two cdroms.I connected my primary harddisk to IDE1 and one cdrom with it.With IDE2 I connected second harddisk it but when i connect my second cdrom it does not boot.
So can anyone help me in it.Please guide me how to connect 2 harddisk and 2 cdroms.

Thanks.
Anurag.

3 replies

by sgt_shultz

when i am troubleshooting this, I use BIOS detection to show me if I have the drives jumpered correctly (or a bad cable or even a bad drive)
don't worry about booting right now. that will maybe be a problem later. but now i think the drives are not being detected. perhaps you have a western digital brand hard drive that needs it's jumper set on master, not sole drive...perhaps you have a cable select cable and don't have the jumpers set to CS on each device (CS cables should be labeled next to each connector ie 'master' 'slave') or...perhaps your cable has come apart from handling.
just try to get each device to be detected to rule out drive failure. take the known good cable off ide1 (or get a spare) and jumper the hd to be 'master' or CS depending on the what kind of cable it turns out to be.
don't worry if you can boot. turn on computer and go into BIOS and see if it found your drive on the master position of the ide2 cable. if it did, repeat with the second device. hopefully by now you will have proved you have two good devices and you know now you can check your cabling by confirming both devices show up in bios. you should see all four. now post back if you still can't boot. perhaps you need to fdisk from a windows startup floppy and set the boot drive 'active'

by thechas

Drive jumper settings for how you have your drives configured:

Primary HDD: Master with slave present.
CD-ROM: Slave

Second HDD: Master with slave present.
CD-ROM: Slave.

If your IDE cable has specific markings on the connectors for master and slave, make sure that the connectors are on the correct drives.

Upon BOOT, enter BIOS setup and make sure that all 4 drive detection settings are set to auto detect.
Or, if there is a drive detection page in BIOS settings, use that to set the drive parameters.

If you cannot boot to the point of getting into BIOS settings, then look for a cable that might have come off of the system.
Check the power cables for all 4 drives. It is possible that one of them is mis-wired. This would cause the power supply to shut down because it would detect a short.

Personally, I don't normally mix HDD and CD-ROM drives on the same IDE channel.
The primary exceptions being:
2 different brands of hard drives.
Desire to burn copies of CDs.

I would set up the system as follows:
HDD 1 as Master with slave present on Primary IDE channel.
HDD 2 as Slave on Primary IDE channel.

CD-ROM 1 as Master on secondary IDE channel.
CD-ROM 2 as slave on secondary IDE channel.

Chas

This discussion is closed to new replies.