5 replies
The motherboard BIOS boot sequence is being used to select the 80GB drive as the boot device. Check and adjust the CMOS settings as follows:
Bring up the CMOS setup menu. This is usually done when the motherboard is powered on and is checking the RAM. Usually you press the delete key.
Look for the boot seqence. This is often found under the menu for advanced options.
Look at the boot sequence. It is probably set to use the first hard disk that it detects.
Since the 80GB disk is on a drive controller that is built into the motherboard, then devices on that controller will show up before devices on add-on controllers. Therefore when the 120GB SATA drive was alone it was the first hard drive detected. When you put a hard drive on the drive controller on the motherboard then that became the first hard drive and the SATA drive became the second hard drive. If you put an additional disk on a controller on the motherboard then the SATA drive will become the third hard disk that the motherboard sees.
My computer with an MSI motherboard has two hard disks on the controllers on the motherboard. If I set up my MSI motherboard computer as you did, with an add-on SATA drive controller, and if I wanted to boot from that drive, I would probably have to disable booting from the hard drives and enable the BIOS to look for additional boot devices. You may be able to select booting from the second hard disk since you only have one hard disk attached to the disk controller(s) on the motherboard.
Please be sure to rate this answer, for better or for worse. Thank you.
by daz'n'ash
I have already tried all that. The problem remained. Thanks for trying anyway.
by thechas
For "most" motherboards, in order to boot off of your hard drive on a PCI controller card you need to set the boot options so that SCSI is the first device listed. Or at least that SCSI is listed before HDD 0.
(Second if you want the option to boot from CD or Floppy)
By default, ALL plug-in hard drive controllers are classified as SCSI devices by the BIOS for booting purposes.
When you had no hard drives plugged into the on board IDE controller, the BIOS may have defaulted to any available hard drive.
Chas
by daz'n'ash
by daz'n'ash
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending