Discussion Locked

set of three beeps from the PC speaker!

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have install a 3D blaster Banshee PCI video card and when I was trying to start up my computer a get a set of three beeps from the PC speaker,and a blank or no video at all my computer is an IBM PC300xl using 168 EDO dimms I need help please help.!!!!

6 replies

by christopherpinto

Remove the vga card and put in another card to test if the vga slot on the mother board has a problem. if the vga comes on then your 3D card has a problem. The beep sounds when the vga card sends no is either off the vga slot on when not working

by at computers

3 Beeps, Are Bios Error Codes, This Fix Is From Bios Central, Do The Following:::1 long, 2 short Video error Check the video adapter and ensure it's seated properly. If possible, replace the video adapter Or The 3 Beeps Could Be This Also::: 1 short, 2 long Bad RAM Reseat RAM then retest; replace RAM if failure continues. This Explanation Could Be Your Problem, 2-Explanations, Which Tell You About The Error Codes And What Needs To Be Done. I Hope This Will Help Explain The Problems You're Having, Good Luck!

by dmiles

Check the memory modules to see if they are seated properly
Three shorts usually indicates a memory problem

by javier

Try installing it in a diferent slot, one used by a working device, if this don?t help, freeze your card, and then wash it with a clothing cleaner,and then use your wife, sister, or mother blower (I don?t think you have one) to dry very well your card, and reinstall it, also you can use a soldedring gun to rectify the soldering points.

This may work.

This discussion is closed to new replies.