Discussion Locked

Sound Card Problems

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Compaq Prolinea 5100E. I installed a CD-ROM and am attempting to install a Soundblaster Pro 16 sound card. Windows recognizes that it is there, it claims to have no conflicts in the system devices, and the volume is not muted, yet we cannot get any sound. Neither CD-ROMs with sound, nor the system sounds work. However, a CD-ROM that runs in DOS works fine. Any help getting this to work is greatly appreciated.

12 replies

by dmiles

Make sure that cd-rom is connected to the board in correct orentation,then go to control panel click on multimedia and check to see if settings match the board setup.
Secon check to see if the mother board has internal speakers and open the cmos control panel and disable the internal speakers.

by ec364

Make sure that you applied the correct Sound driver for your sound card. Then make certain that the sound card cable is connected to the CD-ROM drive. Some PC speakers have a tiny cable that you attached to the sound card in order to hear the sound from the CD playback. Now, when you mentioned that the CD-ROM that ran in DOS worked fine, did you hear the sound from the PC speaker or from external speakers connected to your sound card? If you heard it from the external speaker, then you need theright driver for Windows. If you heard it from the PC speaker, then check the cable I mentioned above and check the driver.

Good luck!

Have you connected the sound card cable to your CD-ROM drive?

by kwangern

btw, did you turn on your speakers?? lol, hope ya did...
anywayz, check the back of your computer, making sure you plug in your speaker jack to output or speaker, it should say it there...that's the only different thing i can think off...it should work then...

by bonner

okay, first have you plugged the speakers in and simple things like that.

Second check that you have the correct driver.

Third there will probably be a volume control or a balance control on the sound card itself - this will be around the backof the computer - next to the speaker and line in connectors. Try turning this the furthest to the left then try it, then to the left and test again.

good luck.

by garynicholson

Okay, first things first, start over at the beginning and do an "imaginary" reinstall (ie. reseat the card, check the cables, etc.) Then depending on your operating system, go to start,settings,control panel,multimedia, click on the devices tab and make sure that their are no other sound card drivers installed on your system. Also while you are in here delete the drivers for your sound card that you installed. Then go to media control devices, and make sure that cd audio device is listed. Thencheck under audio compression codecs and make sure that an audio compression codec is installed (mci,etc) . when you have done all of this, reboot your system and then reinstall the sound card drivers. If the sound still does not work, try seating the card into another pci slot and repeat installation of the drivers (remember to remove them manually before reinstallation!) One last thing, try another soundcard cable (this is a longshot but it has happened to me before). Goodluck and I hope it works.

by gray ce works

REMOVE ALL SOUNDCARD DEVICES IN THE SYSTEM DEVICE MANAGER AND THEN CLICK REFRESH. WINDOWS WILL RECOGNIZE NEW HARDWARE AND SHOULD GIVE YOU THE DIALOG BOXES TO MAKE SURE YOU INSTALL THE DRIVERS FROM THE CD AND NOT WIN'S OWN DRIVERS. IF NOT AND IT DOESINSTALL WIN DRIVERS INSTEAD OF THE DROVERS THAT CAME WITH YOUR CARD, GO TO EACH SOUND CARD DEVICE AND UPDATE DRIVERS USING THE HAVE DISK OPTION. THEN IN MULTIMEDIA GO TO ADVANCED PROPS AND MAKE SURE YOU HAVE THE CORRECT TYPE OF SPEAKERS SELECTED.

This discussion is closed to new replies.