Discussion Locked

STRANGE ACTIONS ON CISCO 1700 ROUTER

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i use a Cisso 3600 router as our main hub, then i use a cisco 1700 on my remote site. When i connect the routers up using 2 modems and a cross over connection, it works fine. However when i place it on the circut, i will only get line up pro down. But here is where it really get strange! If i change the serial interface on the 1700 and 3600 to 2 diffrent ip address it will come up.
eg: cisco 3600 10.10.1.1 cisco 1700 10.10.1.2 While this configuration is corect i will get line up protocol down
cisco 3600 int S0/0 10.10.1.1 cisco 1700 int s0 10.10.2.1 This configuration is wrong but i will get a line up and protocol up.
Help!

2 replies

by warwizard

look at your subnet mask, should be like: 255.255.255.248 (x.x.x.x/29) for 6 node addresses per subnet
255.255.255.252 (x.x.x.x/30) for 2 node addresses per subnet (usual config for a WAN link)

This discussion is closed to new replies.