6 replies
by den inc.
by newitguy
by jdelgado
It does sound like you need to change your boot order and that can be done from the BIOS. This webpage shows the keys you can push to get into bios depending on which you have.
http://www.cyberwalker.net/faqs/reinstall-reformat-winxp/enter-BIOS.html
Typically in the bios you will go to Advanced Setup and you should see 1st Boot Device 2nd...etc. Some BIOS however, like a gateway, has a whole section devoted to Booting. Goodluck
by rcom
There are tools available to undo what you did.
http://www.partition-recovery.com/
You can try it first to see if it works then it's 30.00 to buy the fulll version.
I disagree with the others...
You have correctly stated the boot order is not the problem. It is in fact that the new active partition on the hard drive does not have a system on it. Therefor, even if you block out all other boot devices in the BIOS your system will not start up.
You must get into FDISK and set the correct partition as active--period.
You can use a DOS style startup disk with the (correct) FDISK utility and fix the problem from there.
I said DOS style so that you understand that it won't start the graphics based OS, rather a command symbol environment.
Also, it must be the "correct" version for your disk format. Use a Win98 or WInXP startup disk for FAT16 and FAT32 formats, and a WinXP disk for NTFS formats. If you have Linux the process is different and depends on your setup--let me know if that's the case.
Also if there is any doubt that you have overwritten the system partition with the new one then you must recover the old partition. And that can be a real joy! There are programs available that do it really well. I have had several opportunities to prove that they work, thanks to people experimenting with their computers...
However it sounds from you description that you have seen two partitions. As long as you see two partitions then cahnge the active partition and that's that.
by denodave
Albert Franco II is correct. The system has the new (blank) partition marked as active and there is no O/S. That's why it's trying to boot from the CDR. Just mark the original partition as active and it should be fine.
A good idea is to make a backup of your MBR before doing things like this. The Maxtor MaxBlastIII software will allow you to create a MBR backup.
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending