Discussion Locked

Stylus Photo R300/ USB problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My client has an Epson Stylus Photo R300 inkjet connected to PC with Win ME. thru' a powered USB Hub.
Problem - Epson Monitor can't see the printer to give ink status, nozzle check it just searches endlessly. Test page spools but doesn't print, nothing appears queued to the printer. But the Active X diagnostics from Epson Support website manages to activate Nozzle check, head cleaning etc.. The printer properties shows three differing EPUSB ports none of which can be deleted, port in use by printer message. It shows the in use port as "EPUSB1". The diagnostics says it should be the "EPUSB1 Stylus Photo R300". Tried all the uninstalls re installs of printer and USB drivers, downloaded the latest drivers from Epson etc.. Any one got an ideas?

5 replies

by w2ktechman

try taking the hub out of the picture, see if it still errors.
then try replacing USB cables to see if one is faulty (this hit me a few times)

by g.brown

Try ... unplug the printer .. boot into safe mode .. in device manager make sure you delete all of the entries for USB .. both the devices and controllers.
Don't plug the USB in yet ... boot the machine normally ... once it has loaded up and found the controllers again .. then plug the printer back in and try.

by tommo

Poster rated this answer.
The problem went away after following this answer - thanks. Sorry it's taken so long to reply :-)

This discussion is closed to new replies.