Discussion Locked

Suspend to disk partition not found...

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I've been reading about the tool for the AMI Bios, HDPREPEZ and HDPREP. I have a user who has a WinBook XL. He had a boot sector virus and decided to format his hard drive. He originally used HDPREPEZ, according to the displayed message, which read "Run HDPREPEZ...". I read that I need to have a version of this utility that matches the BIOS version and that I may also have to flash the BIOS as well. When I called the tech support for this laptop, they told me the hard drive or controller sounds bad. I don't think that is the case. I tried to load Win98 back onto his laptop and realized that he needed this utility. I'm not too familiar with laptops at all. My question is, should I try and load Win98, then load HDPREP from DOS, or should I load the utility first, then Win98? I also read that HDPREPEZ is the first release and I would need to use HDPREP if the EZ version did not work after flashing the BIOS to a newer version of later than 1.00. The BIOS version is already at 1.05, will I be OK with a 1.9 version of the utility? That's the only version I have found to download so far. Any help would be appreciated, I'm not even sure I'm asking this question in the right context! Thanks, in advance.

2 replies

by richard_barsby

Hi you will need to create the suspend to disk partion first using whatever utility program that is provided with the laptop or that can be down loaded from their website then you can create the dos partition and format and then install Windows.

Rich

by spazzy814

Hi,
I have used the utility from the manufacturers site, created the partition, flashed the BIOS, and reloaded Win98. For a few days it was fine, then he got a "disk write" error again. He was asked to run HDPREP again also. I had to boot from floppy and bring the system up, it worked fine, and then the "disk write" errors came back. "Disk write error to drive c: insert bootable media" I was told that it could be a physical error on the hard drive, but if that were so, I would think that the disk write errors would be more frequent or some other warning would occur? Any other suggestions? Sometimes he just reboots and it's fine for a while before the error occurs again. I checked the physical connection to the drive, and that is ok. Scan disk does not bring up any bad sectors or clusters, is there something I'm missing or forgetting to do? I checked the file that the HDPREP created, and it has some free space in it, I thought the file may be too small, but that's not the case either. All help is appreciated.

This discussion is closed to new replies.