Discussion Locked

system will not detect floppy or hdd

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I can't get my bios to detect my hdd or the floppy either. It is an old system that has to have a serial,ide,floppy adapter card. it is a winbond with the fcc id of f825k4pti227w. how can i install the drivers if the floppy is not working. any help would be greatly appreciated

7 replies

by maxwell edison

Greetings,

The first thing to check, or course, is your cableing. Make sure they are snug and haven't come lose. Make sure your controllor card is also snuggly seated in the motherboard. If all that is ok, I'm afraid you have a controller card that failed. However, you can go to Micro Center, CompUSA, or any other computer reseller and get a new one for probably under 20 bucks.

Good luck,

Maxwell

by purple713

If there is a light the stays on the floppy drive when you boot the machine, the cable is not seated properly. Whenever you are working in the machine remember that the side of the ribbon cable that is red is suppose to face the power supply on themotherboad. The twisted side of the cable goes to the floppy drive. The red strip side (going to the floppy) must face away from the power source on the floppy drive.

Hope this helps.

by paulp

If your system is so old that you have an IDE controller card rather than an integrated IDE controller, the BIOS will not automatically detect your hard drive. You must input the values manually, or select the drive type number from a listing. You may need to consult the drive manufacturers website for that info if it's not printed right on the drive casing.

This discussion is closed to new replies.