TCP/IP Dialin

Dialin to where? You'll need to know the correct settings, and then configure them in the Dialup Networking properties. You can choose to use TCP/IP and set all the necessary configurations from there. You may also need to setup and configure a dialup adapter and TCP/IP in Network properties.

Configuring TCP/IP:Select,Start,settings,control panel,network.Click to add network component
To add protocol:on network properties,click add,network component dialogue appears
select protocol and click add,select microsoft,select protocols from the protocols list.click ok
You will have to install the NIC'S and configure the hardware before this step.

It sounds like you are wanting to setup dial-in to your PC. First you need to install TCP/IP in you network properties. After you reboot you will need to go into 'ADD REMOVE PROGRAMS' and install 'DIALUP SERVER'. After the files are copied you will reboot. Go into MY COMPUTER/ DIALUP NETWORKING, then click on the connection menu and DIALUP SERVER. You will need to allow caller access and set the password. Hope this helps you out.

To setup to Dial-out from your system:

Go to your control panel (start - setttings - control panel)
Open Network properties

Add Adapter - Microsoft - Dialup Adapter
Add Protocol - Microsoft - TCP/IP

Use whatever settings your ISP gives your or take the defaults which should work.

Reboot

Open Windows Explorer
Go to Dialup Networking and use the wizard to setup your dialup link.

This question was auto closed due to inactivity