Discussion Locked

toshiba Te 2000bootup lock

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
HI ihave atoshiba te2ooolaptop it only shows powerled and hddled bliks twice when itry booting it en thats all it wont go past there no display no beeps anyone out there who can help pliz

4 replies

by hal 9000

Well provided that the NB has not suffered any physical damage like being dropped I would first be looking at the CPU as a possible culprit.

If it is UG then return it for repair and if it isn't pull the M'Board and look very closely at it for any signs of corrosion. Batteries do leak and can cause quite a lot of damage so look for physical signs of damage first.

Col

by hal 9000

Also check the mains adapter as it may no longer be working so if you have a means of measuring the Voltage measure it and check the output against the rated output on the adapter.

It is possible that the Mains Adapter is no longer working and that the battery is now flat so you only get the briefest of signs that the unit is working before it runs out of power.

Also check where the plug from the mains adapter plugs in and make sure that the center pin isn't bent or pushed in.

by sgt_shultz

have you tried powering down the notebook and taking the battery out. wait 10 minutes and put it back in and try starting it up.
i wonder if it is stuck in hibernate.
have you tried a boot disk?

by w2ktechman

Does the notebook have RAM in it? could the display be failing?
Try resetting the BIOS, if you cannot try flashing it. Flashing it should restore the default settings. If this does not work, it sounds like the System board probably needs replacing, or the Memory or Processor or Bios needs replacing.

This discussion is closed to new replies.