Discussion Locked

Trap e error on NT4 Workstation

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am receiving an inconsistent fault during boot up on an NT4 workstation. The machine will boot up ok for say six times then it will give the error "trap e error". The error relates to the setup of scsi devices and the boot ini file.
Any ideas?
Thanks

Gavin

3 replies

by syscokid

"AVOID "TRAP E" MESSAGE WHEN BOOTING

Are you experiencing a "Trap E" error message when booting your NT workstation? If so, the problem may be that your SCSI BIOS doesn't have full INT 13h support. Here are a few suggested workarounds. You can try creating an Ntbootdd.sys in the C: root that is a copy of your SCSI driver (it must be less than 64KB). Or, if your SCSI BIOS has full INT 13h support for just one or two drives, make the boot disk a supported drive. In the worst case, you may end up replacing your SCSI
adapter with one that has full INT 13h support."

I have no idea what that means, but I found it here:

www.nerdworldnj.com/tips/windows_nt.htm

This discussion is closed to new replies.