Discussion Locked

tv out video (movie display)

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an ATI Radeon 7200 w/ TV out. I have the SVid cable plugged into my tv. I am able to get a picture just fine. But when I try to run a dvd or any video file regardless of where it's located (on the cd-rom, dvd-rom, or my hdd) the picture is only able to be displayed on my monitor. I've turned off my monitor and tried playing it with only the tv on, and I still get no picture in the player (windvd, powerdvd, or media player). Everything is updated and current. I've tried turning down the hardware acceleration, and rebooting w/o the monitor connected. I just can't get the movie to display.

4 replies

by jorich

I have encountered this type of problem with my NVdia card and found out that you need to set your Card output preferences before an RGB signal comes out from your TV out. try checking your display properties advance settings, or your card driver property settings. Mine was in the Display properties.

Regards,

Jov

by kimharris

With the ATI the settings are in the driver in display properties, there will be a tab that says displays and on that tab there will be three settings, click on the red corner of the TV and it will send the signal. However, the Radeon is not able to show two displays at once if this is what you are doing. Just one or the other.

by kimharris

Don't forget to set your TV to line out 1 or the proper setting, depending on which line your using as an incoming signal.

by smilee279

I've tried rebooting without my monitor cable plugged in and with the tv out plugged in. I still can't get the movie to show up.

This discussion is closed to new replies.