Desktop

Ask something
Discussion Locked

udate for "cannot add or see printers"

0 helpful
8 replies

by rick h

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

This is not a question, I previously asked about the above. I know for a fact that it is caused by one of the microsoft "security updates". I've done it twice . I had to do a repair install to correct it. I do not know which update it was since I did not sort through them. I may try to figure it out but I doubt it will happen right away as I will have to keep doing repair installs each time. Thanks to all who answered me before.
Rick

8 replies

by rick h

Sorry, is that bad? I'm kinda new to this points thing. My purpose was to be sure it was seen. Many others have posted and e-mailed me that they were having the same problem. Maybe Microsoft will so something. I also posted on the Microsoft technet. If assigning points is bad I'm sorry, perhaps you could explain.
Thank you,
Rick
P.S. this unacceptable rating is ONLY to keep it open.

by willcomp

Rick,

Post a comment to your question with link to previous question.

You can change point value.

Did you check how RPC was starting after installing updates? If you don't know what I'm referring to, post a comment.

Dalton

by willcomp

First, quit rejecting answers and place your comments under your question.

Go to your previous question and copy and paste URL link in a comment to YOUR QUESTION ABOVE.

RPC (Remote Procedure Call) is a service. Ensure that it is loading automatically and that Log On is set to Local User Account

by rick h

Learn something every day. Thanks for your help. I didn't see any way to paste a link to my previous post so I pasted it in here. But it was too many characters. Looks like I could use one more lesson...how to insert a link to my previuos post.
the title was: cannot add or see printers but they work
Thanks again,
Rick

by rick h

Can someone tell me how to create a url link to my previous question as suggested? I can select and right click to do a normal copy for copy/paste but I see no way to create a link.
Thanks

This discussion is closed to new replies.