Discussion Locked

Ultra100 Bios problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
After applying a BIOS update I am getting a message saying 'Ultra100 Bios not installed' to which the machine freezes. It does not continue with F1. I have reset CMOS and checked every setting in the BIOS. Has anyone had a similar problem ro or could offer any help? The mobo is an ATA100 694D PRO (Award Modular v6.00). The problem started after bios update (correct one). Have also tried using all 4 ide ports but with no success. Any help would be appreciated.

5 replies

by thechas

My first thought is that you got a BIOS for a different revision of your motherboard.

Double check the manufactures web site to verify that the BIOS is correct for your specific motherboard.

Next, generally speaking, never connect a CD drive to an on-board extended IDE controller. Many motherboards do not properly recognize CD drives when connected to the extended controller.

Some of these systems have a key you can press while the Ultra100 controller is searching for drives that allows you to enter the Ultra100 BIOS setup.
Give that a try.

Chas

by thechas

Try disabling the Ultra ATA controller in BIOS settings, and make sure that the On-board ATA 100 controller, SCSI, and other device is NOT on the boot list.

Chas

by dmiles

I would run the Start-windows update to make sure that you have the newest updates.

In addition Cleanup the startup stuff. In win98/Win ME/Win XP - Do a Start - Run - msconfig, startup Tab , or for win95 , NT or win2k,
Download the Startup utility free from
http://www.mlin.net/StartupCPL.shtml
Run it and it will show you everything that is listed in all the possible startup
places, and allow you to disable things one at a time until the problem is eliminated.
A lot of probelms are caused by excess old baggage - programs that have not been properly un-installed. Startup Cop will eliminate leftovers and un-wanted programs that you no longer want.
Older Antivirus programs and Norton Utilities have been known to cause problems
try disabling them also !

Update and run 2 good, updated antivirus program- Norton, McAffee etc.

Then run SFC from the Start-run command, and have it fix any broken files.

ALso check into getting driver updates for ALL of your hardware, BIOS, VGA, motherboard etc.

Do a Defrag of all partitions from SAFE mode !

Make sure that each partition has at least 15% free space.

Check your swap file settings.

You may try doing a scanreg /fix from a DOS prompt.

You may try doing a scanreg /restore from a DOS prompt
and select a registry date from before the problem started.

Check the IE version and try to do a repair from the add/remove in the Control panel - choosing remove gives you a repair option.

by bainbridge

I don't think you read my post properly, I am not getting past BIOS on the boot. Can't even initialise the FDD or CDROM to flash it.

by rindi1

try applying the update for the ata100 adapter again. Just make sure you have the correct version.

This discussion is closed to new replies.