Question Locked

Upgraded to WSUS3, now PC's wont show. Help?

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I upgraded my WSUS from 2.0 to 3.0 and now when I open into the council there are no pc's shown. Nothing shows up, whereas before the upgrade all my pc's were shown and updating fine.

I am trying to find the solution without have to wipe this and do a fresh install. Any help is greatly appreciated.

Thanks in advance.

2 replies

by churdoo

Double-check that when you set up your WSUS 3, that it's using the same exact IIS website name and port number as the old one was, obviously it's what your GP is telling the workstations to contact. Sorry I had to point out the obvious first.

If that looks OK, then from a RUN or CMD prompt on one of the clients, "wuauclt /resetauthorization /detectnow" and see if the client shows up on the WSUS server a few minutes after issuing the command.

Check the bottom of the c:\windows\windowsupdate.log for clues if none of the above produce results, though I think that the /resetauthorization will probably do the trick.

This discussion is closed to new replies.