Discussion Locked

USB Drivers Install Problem

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I recently built a new computer with an Azza 601BM MB and Celeron 633. I'm using Win98SE. I am having a problem getting my USB ports to work. When trying to add hardware, I get a message that says it will now install the drivers, but the next dialogbox says it can't find the correct drivers (?!) If I remember right, there is a Code 28 message, whatever that would mean. To put it in a nutshell, how can I get my USB ports to be activated? I want to connect a printer and scanner to my computer.Thanks.

8 replies

by true_texan

Your problem sounds like Windows doesn't have the correct drivers for your USB ports. Check the manufacturer's web site to see if they have the drivers. They should also have instructions on how to install them.

Hope this helps!

by mphoffar

two things here...

A lot of times the USB is disabled by default in the bios so make sure that is enabled in there.

The other thing you'll want to do is go to http://www.azza.com.tw/Layout.asp?Page=drivers (no spaces in that address) and download the VIA 4 in 1 driver from there and install it. There will probobly be an IRQ minidriver during this installation, I would suggest that you install that also.

Good luck to you

Mark

by zoka11

in the bios make enabe for usb
in the propeties you have 2 controlers
/root and 1 for mb

This discussion is closed to new replies.