Discussion Locked

VPN from behind a DSL Router

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am using Telocity DSL and am trying to VPN into our corporate network, I have tried bot LinkSys and NetGear DSL Routers with no success. I can authenticate against SecureRemote but can't access anything beyond that,

I am using W2K on my laptop,have a static IP set up in the router, verified the subnet and gateway info. We have many remote users who need to access the network in the same way but no one is having any luck.

Any pointers as to where to start to resolve this would be greatly appreciated.

8 replies

by rleong

I would first verify the setup of the VPN on my server. If you are using 2000 Server then be aware that there is a bug in the VPN server setup, and that it must be done manually. There are a few white papers on setting this up on Microsoft's website.

Second, make sure that the server has DHCP set up or that it has a range of static addresses it can assign to remote computers as they connect.

Third, make sure the user account has permission to come in via VPN.

Fourth, look at how yourserver is communicating to the Internet. If you are using one of the DSL Routers, you will need to make sure that you have the proper ports open, (1723 and 47) or that your server is on the DMZ. Note: I have had problems with getting these ports to work with the Linksys Router. Only way it would work was to put it on the DMZ, (this is with the Linksys).

by no problem software

I have a similiar set up and the same problem. At home I have a Linksys router and several computers. I use the Nortel extranet client. When I connect to the VPN from a machine running NT the VPN works flawlessly. However if I connect from the Win2k machine sometimes the connection works but only for 15 or 20 minutes. Most times it never connects. I have different versions of the clients on the two machines because of the two OS.

by nativenh

Most routers are using Network Address translation or NAT. The RFC for PPTP is not forgiving of NAT so you need to make static NAT entries into your router. On the Cisco 6xx series SOHO router this entry would look like this
set nat entry add 1723 IP.
set nat entry 0 0 47.
Write

If you are using DHCP on the local PC, it is better to change to a static one, this will avoid you having to update the NAT entries. The other thing to keep inmind is the global address or public address (address assigned to the WAN port). Some providers use DHCP and other are static, should the global address change, the NAT will need to change also.
One more thing, this works for PPP mode, bridge mode presents another challange.

This discussion is closed to new replies.