4 replies
by kargreig Accepted solution
by Former member Accepted solution
Attach one end to your computer and the other end to the router. Your computer should auto connect.
Please post back if you have any more problems or questions.
by nepenthe0 Accepted solution
You should be able to run an Ethernet cable from the modem directly to the laptop. If you want the option of wireless connectivity, the solution is a [i]wireless router[/i], otherwise known as a [i]NAT[/i] (Network Address Translation).
Linksys makes inexpensive, reliable wireless routers:
Installing a router significantly enhances your network security, by establishing a 2nd firewall that ignores all unsolicited probes by malware.
If you decide to purchase a wireless router, run an Ethernet cable from the modem to the router. If you currently have a desktop computer connected to the cable modem, you would reroute the Ethernet cable from the desktop to the router.
With this setup, you can also connect your laptop directly to the router with an Ethernet cable if you wish, but [b]G[/b] standard wireless transfer rates are so fast that you should not notice much difference, and the new [b]N[/b] standard promises even faster wireless transfer rates.
Rick/Portland, OR
by oh smeg Accepted solution
But you do have to turn off the Wireless connection and make sure that the Ethernet connection is active and correctly installed.
It is possible that the RJ45-LAN-Ethernet port has been disabled or it just may not be setup correctly or maybe it has been disabled you really need to look at the Device Manager to see what if anything has been done to the device.
In XP this is called the Network Adapter and in that heading there should be the Wireless and Wired Connections visible. If there is a Yellow Question Mark then the Ethernet has most likely not been installed. It really depends on who setup the system, what the used to load it and any changes that where implemented after the OS was installed.
If this is a Factory Install of some form of Windows then all the drivers should be loaded but if it was installed from a Windows Disc not a IBM System Makers Recovery Disc then the drivers for most of the hardware is unlikely to have been installed.
Col
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending