Discussion Locked

Where did my sound go?

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

OS: Win98
I have a relatively new Epox motherboard with an 800 MHz AMD processor that has integrated game port and sound jacks (speaker, mic, and something else). Recently, I tried to install an internal PCI ADSL modem I got from my ISP, but for whatever reason it did not work so I sent it back. I reinstalled my old 56K modem after I took out the ADSL.
Somewhere along the line, my sound stopped working. There is no longer any sound coming out of my speakers. The sound icon is visible in my system tray, and when I run an application that uses sound I can see on the Wave indicator that it is processing sound. None of my applications that use sound complain about a sound card not being available or whatever. I checked the Device Manager... the sound card is available and is not conflicting. I reinstalled the drivers, and then I even reinstalled Windows 98. No sound.
I'm out of ideas. Can anyone help?

13 replies

by richard lane

Sounds like something has come loose inside the box when you pulled out the ADSL. Open the box up again and make sure that all the cards are seated properly and there are no cables loose/disconnected and try again.

by edwardhammerbeck

Thank you for your answer. I verified that everything was seated firmly, plugged in to the appropriate places. Everything was, and I still don't have sound.

by retrojohnny

When you installed the PCI modem, did the modem have sound capability? Some modems have pins where you connect a jumper cable from the modem to the sound card/motherboard sound. It's possible you overlooked this when replacing the 56k modem, and didn't hook back up the sound cable.

And I assume that you've double-checked which jack the speakers are plugged into. And check to make sure that during the move/installations, you didn't unplug any other speaker cables (power, and where the sound wire plugs into the speaker itself). Also, to eliminate the possibility of the speakers going bad at the same time you attempted your upgrades... try them on another system. Or try another pair of speakers on the system you're currently working on.

Good luck in finding your solution!

by edwardhammerbeck

Thanks for the response. There was no connection between either modem and the sound equipment. I verified that the speakers work. I tried to plug other equipment into the sound card jack... it's an onboard sound card and game controller, by the way, integrated with the motherboard...

I also checked all the connections and they were tight.

by jhackett

Double check your speaker connections. Make sure your speakers are powered up and check that you do not have your sound muted or volumn turned down too low.

by netuser

Verify that all connections are good and get the power it needs. Then check your volume controls. There can be several places to change the volume. Sometimes individual applications have a volume control.

Normally, it gives you an error message at boot time if there is something wrong on your configuration. To verify, check your device manager and make sure the device is listed with no yellow exclamation points and the status is working properly.

Usually, a corrupted driver will give you errors like general protection faults, page faults, or system lock up. Try to uninstall and reinstall your driver to fix this problem.

I recommend to run SCANDISK before reinstalling the driver and if possible try to get a new driver from the manufacturer.

I hope this will help you a bit.

by edwardhammerbeck

Thank you for your ideas. I checked every control panel or other 'software interface' pointing to the PC's sound system I could think of. All were set as expected. Nothing was muted or set too low.
I updated my motherboard's BIOS and the drivers for the onboard audio (which is what we're talking about here). That did not help. I also made sure I had all the most up to date MS Windows updates. I have run scan disk and all the other diagnostic/system tools that come with Windows 98.
Still no sound.

by md_hashim

You need to check the the mixer device properties on your system. To do this double click the sound icon on your system tray, under the options menu, you'll see the Properties - when selected this will list the properties of teh mixer on your system. Select the right option and you should be all set.
Cheers,
Hashim

by sergey kovzik

wow... even reinstalling windows didn't help? Hmmm... But was it clean install or just over old version? If over - nothing strange. if you got mess in registry and belong files - it may still exists. but if it was install from scratch - then you have definitely some hardware problem. This case you can do only two things. try out to reset CMOS - you should have special jumper on motherboard (but it would be nice to save current settings). if even this won't help then it is very possible that PCIboard fired out some circuits in you motherboard. if power difference between DSL-line and your speakers was too big and PCI card wasn't properly designed and motherboard had no some kind of internal protection or it wasn't able to compensate such leveles, then output amplifier may just burn out. err, I assume that you checked your speakers and they produce sound if connected to other equipment. what else... you can to remove all cards from PC, leave only video and resintall windows from zero. but it will help only in case if your modem has voice capabilities and its drivers crossed out some way with sound drivers.

This discussion is closed to new replies.