Discussion Locked

Win 98 p2p ntwk: Unable to browse ntwk

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We set up 3 Dell Optiplex p100s with 3Com onboard nics as a network using a 10 mbps hub, NETBEUI, TCP/IP, 3Com adapter, windows logon, file and print sharing and ICS. Network neighborhood click gets error message "Unable to browse the network" and we can't determine why. Windows 95 was first upgraded to 98 on all machines. AOL works fine on its machine.

9 replies

by bigcheif

Are these older computers with an older 3com nic on board. The reason I ask is because a have some 3Com nic cards 10mhz that I had alot of trouble getting to work with a windows 95/98 network. You might try looking for the latest drivers for the card. The older drivers install and look like they are working but have a problem. Could try a couple of new cards. Do the cards look like they are talking on the hub when you turn on the computers?

by catlover

The Dell Optiplex GXL1533 service tag 7TJ3H has a 3Com 3C905B or 3C905C onboard nic chipset. Will dnload new Dell drivers but an SMC card w/driver installed concurrently got same msg. Link lights are on but no blinking. Yes, we've had Dell/3Com trouble on school boxes and had to go to Intel nics. But the above box used to work on the prior network. But thanks!

by saihib

If the lights on your NICs are on and the hub shows 3 connections, then your hardware is probably ok. Are all your subnet masks exactly the same with consistent IP addresses. Does each machine have something shared? In properties for File and Printer Sharing for Microsoft Networks make sure Browse Master is set to Enabled and LM Announce is set to Yes. Make sure that the Workgroup name on each machine is exactly the same.

by catlover

Masks are 10.0.0.X/255.255.255.0 on all 3 boxes (.1 .2 .3); full share is on; BM is enabled; LM is yes; Workgroup is Workgroup. Going by the book, so problem seems extraordinary. Feel that 98 can't always keep up with all the changes. Dump all and start over? Thanks!

by guy west

I know this is basic but have you you tested your cables? Are your cables no longer than the specificed distance they should be? (328' for ethernet, shorter if you're using coax). Are you using a known good hub? I bought a brand new 8 port hub not too long ago and was faulty right out of the box. Good luck.

by catlover

Thanks, pays to check equipment but it all checks ok and cables are 10' or less. I now have a Compaq Tecra notebook which sees both Dell Optiplex GXL's but the Dell doesn't see the Compaq so I think it must be a setting in the Network settings box. Am running NETBEUI TCP/IP and ICS with all bindings showing ok except ICS bindings box which is blank. Device resources shows problem with ICS but haven't tried Internet on all boxes yet. Also, neighborhood shows ok when dynamic IP addressing button is clicked instead of static addressing, but I have no WINS, DNS, or DHCP available.

by ryan.g

Try to ping one of the pc's. Make sure cables are good. Double check tcp/ip settings

by catlover

I ended up having to start over: dump and reload all network settings and reboot. Then it all worked ok with only an occasional refresh needed.

This discussion is closed to new replies.