Well there are utilities available that write 0's to every sector of any HDD. I use an old IBM one called Wipe and ZAP wipe writes 0's to every sector of the HDD and Zap only writes 0's to the MBR or File System so bits of data can remain intact on the HDD.
You will need a Windows 98 Boot Floppy or something similar to use these as they all work in DOS and you just allow the computer to boot from the floppy and then replace the floppy with the utility and in the case of the IBM one all you need do is type in wipe 0 to wipe the C drive wipe 1 to wipe the D drive and so on down the number list until you have wiped every drive in the computer. Note this means a HDD not a partition so if you have several partitions on a HDD just typing in wipe 0 will wipe the entire C drive.
Failing that you can use the FDISK utility that is supplied with Windows 95/98/ME/NT or even the old DOS Boot Floppy when the computer boots from the floppy just type in FDISK and follow the prompts these will vary between different versions of whatever Boot Disk you are using but if you have an NTFS partition/s all you need do is chose the Delete NON DOS PARTITION and then type in the partition number that you want to delete and then add the name if there is one and press y this will delete individual partitions and you should always start at the last partition and work your way back to the first partition. But this only removes the MBR from the HDD and not the data that may be on the drive/partition.
Similarly you can use the Windows XP setup to delete any partitions/drives that are present on the computer and reformat them. When you do this never use the QUICK FORMAT option as it will not format up correctly particularly if you have been experiencing problems already.