Discussion Locked

Win2000 paging file and dynamic disks

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Here's the situation: I just converted my c: drive to dynamic disk and now my paging file size has changed, corrupted or deleted. I tried to change it back to 750MB (I have a lot of RAM and disk space), but the system will not let me. By that I mean, it will let me change the values, but it ignores them and defaults to a temporary 20MB paging file. According to MS's (alleged) knowledge base, I can set the initial and maximum values to 0, reboot, then set the values to thier appropriate amount, but this does not work. Any ideas/suggestions?

5 replies

by gohuskies

Logon to the local machine under the account used to install this OS.Once logged on to system you should have no problem changing the pagfile size.This will require a reboot for the change to happen.

If you logon to machine under any other account this change will most likely not
change.

I would also recommend to have the pagefile clear itself at reboot.This is a good way to avoid a corrupted pagefile.

To make this change, edit the following registry key.

[Hkey_Local_machine\System\CurrentControlSet\Control\SessionManager\MemoryManagement\]

ClearPageFileAtShutDown = 1

by rick_e_b

Thanks for you reply, but I am using the same account. I've also noticed that the paging file size listed in the registry is correct and the pagefile.sys file is the correct size, but I still get the message at logon stating that my paging file is non-existent or too small. I may have to reinstall to clear this up.

by vsncorp

Hey I am having the same exact problem. I tried almost everything but nothing seems to work. If you get the solution to the problem can you Please Very Please send me an email at vsncorp@yahoo.com

This discussion is closed to new replies.