Discussion Locked

Win98 Fatal Exception Errors *sigh*

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Have a Pentium 3 450 on my bench that is giving me fits. Upon bootup I immediately get a Blue Screen of Death with "A fatal exception 0E has occurred at 0028:C0005338 in VxD VMM (01) + 00004338. I have swapped out the RAM (64 megs DIMM), reloaded Win98, swapped out the video card and run Norton AV and scandisk. Per my Troubleshooter readout, it flunks the video memory test. What's next?

5 replies

by frostbite_99

A couple of suggestions:

1) If you have a Network Card in the machine, remove it and try booting. It might be conflicting with the video.

2) If you have built in video capabilities on the motherboard, you may want to check the jumpers per the manual for the motherboard. Make sure that you have the on-board video turned off and are not having a conflict with the video card.

3) Finally, check your BIOS settings. Usually in the advanced area there will be settings for video setup. Without knowing what BIOS you are running it is hard to know what to try and changing. Check all BIOS settings with VIDEO.

Hope that helps.
Erik

by paul d. masley

Jim:
You are not going to believe this. I saw the same error in my attempt to upgrade to ME. VMM is your virtual memory manager. I got the same error with WIN98, NT 4.0 and NT Server. I replace a memory stick befor the attempted upgrade. You stated that you swapped out the RAM. Without knowing what board/bios you have, I would still look at the memory stick. Change the stick to one that you know is good (Go down to a 32 meg if needed. WIN98 will start and run on that). Remove all cards(sound, modem, network, ect) other than the video card. Forget Norton AV. It can cause more problems than needed. FDISK the drive, then reload WIN98. You can get the "Blue Screen" with a bad video card or with a card that is not set up right in the bios. Check the bios settings. You may need to manually set the PCI slots or drop the AGP slot down to 2X or less. I fought with a PII 350 for three days before I discovered the bad memory stick. Good Luck!

by jim

Hooray! It was TWO bad video cards... both listed as 8MB but only showing 4MB in Troubleshooter. Put in an 'old reliable' and it worked fine. I really appreciate the help!

This discussion is closed to new replies.