Desktop

Ask something
Discussion Locked

WIN98 missing file

0 helpful
3 replies

by lovetheavguy

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have WIN98 2nd edition and I just upgraded my CPU to a 333MHz.
Every time I boot up I get a missing C:windows\system\VMM32\enable.dll Where do I find this missing file? What are the commands? And more importantly, how do I install it where it should be?

3 replies

by thmiuatga

Impala;
The dll files are installed automatically during the running of windows setup. There was probably an interruption of the process.
If you call microsoft they will tell you what I am going to tell you: reinstall windows. this is the only method to repair/replace missing or damaged files.

by isa_lost

"find files or folders". look for "enable.dll"if it is in your computer this should find it then go to windows explorer. once in explorer goto the point you found it in "find files and folders"copy it and past it to C:windows\system\vmm32. At this point windows will find it at boot up, as it is where it should be now. However, if you cannot find it then reload windows.

by barmaley

Run System File Checker - Start/Run and type SFC.
Chose "Extract one file fron installation disk"
and type missing file. Click "Start"
Chose location of installation files and destination. Click OK and PRESTO! - you have restored file.

This discussion is closed to new replies.