Discussion Locked

Windows 95 Static IP Address

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Windows NT 4 network with Windows 2000 clients and a few Windows 95 clients. All clients use DHCP. I need to assign a static IP address to one Windows 95 client, but when I open the IP properties for the NIC and select "Specify an IP address" I cannot enter an address. In fact, the cursor does not blink in the IP address field. Is there a setting that I can change to fix this?

9 replies

by kyu

*** Can you can ping the server from your w95 computer? If not, your TCP/IP or your NIC driver might be botched. Remove and replace them.

*** Is your NIC working?

*** Is there a mis-match of 10 or 100BaseT speeds?

by brothertech

From what you described, your TCPIP protocol is corrupt. You will need to uninstall TCPIP then uninstall the NIC. I have seen where you sometimes must physically remove the NIC also. After doing this reboot and then shut down. If you removed the NIC, replace it and boot up. Install NIC driver then TCPIP and configure.

If problem persists, I would try another NIC.

Good luck.

by lazyvanbee

Make sure DHCP is unticked in TCP/ip properties. If this does not work unistallTCP/IP and reinstall. You cannot use DHCP and a Static IP address together.

This discussion is closed to new replies.