Discussion Locked

windows 98 SE

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Windows 98 SE doesn't recognize my US Robotics Modem and everything checks out with no conflicts. is it possible windows sees the modem as a pci multimedia device? i don't have a pci multimedia device because the multimedia is built into the motherboard, but windows keeps telling me that i have a new pci multimedia device.

12 replies

by jfitz

I had a similar problem and was able to fix it by removing the
"?" device in device manager and any modem that might be
listed. Then shut down your machine, remove the modem
card from the mother board and restart. If multimedia
device does not show then it is the modem. Reinstall the
moden in a different slot if available and select the driver
yourself.

Good Luck

by volovoy

Yes, it's possible. Sometimes Windows can't recognize PCI modem.Try to find drivers for your modem on the Internet and install them on your computer. Or if you have floppy for your modem, put it in floppy drive and let Windows find drivers from floppy.

Alex.

by thechas

In device manager, remove the muti-media device.
Shut down, and remove the modem card.
Re-boot, and install the driver.
Shut down and install the card.

Re-boot, Windows should now ba able to find and instal the modem.

by l j quick sr

This is common with PCI devices, Go to Start, Settings, Control Panel, Modems, from there check Don't detect my modem, I will install it from a list. At the list click on HAVE DISK and insert the CD-Rom that came with the US Robotics Modem.
Most of these modems recommend you install the drivers first to avoid this problem, If you install the driver first, Windows will recongize it when you reboot after installing the modem.
Good Luck.
LarryQ

by shanghai sam

1)the modem- youdeleted it either from the modem applet in control panel or from the dev mgr. a defect in winmodems leaves the registry entries when you do this so the modem will not re-enum.

try this from Q190554
You need to remove the registryentries before the Windows-only modem can be detected again. For 3Com US Robotics modems, use the Wmregdel.exe tool that is included on the Windows 98/98 Second Edition CD-ROM to clear all of the Windows-only modem-related registry entries, and thenrestart your computer. The Wmregdel.exe tool is located in the Drivers\Modem\3com-usr\Winmodem folder on the Windows 98/98 Second Edition CD-ROM.

pci multi media dev is a sound device. it sounds again like you pulled the drivers and this is an ensoniq or creative sound card. the only way to install this is to run the setup for the sound card which will pull the reg entries for the sound card and reload them

good luck!

This discussion is closed to new replies.