Discussion Locked

WIndows 98 SE and DOS modem connectivity

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am supporting an office that has decided to upgrade its PCs, they've purchased DELL GX-200 (PIIIs) with Windows 98 SE. Unfortunately, now I have a DOS legacy application that I'm troubleshooting. According to the application's support team,the OS shouldn't be a problem. It is working on the most part, but the portion of the software that needs to dial out to transmit data is not. We connected a external Hayes 28.8 modem to it for the application. It's on COM2, the configuration in the DOS program has also been set to COM 2. I can dialout, using phone dialer within WIn 98 SE , but while in the application, through a DOS box, it won't find the modem. If I reboot the pc and hit F8 to command prompt, then go to the application, then it is able to dial out and work. I see that there are different variables within the DOS shortcut I can play with, but I was curious if anyone has been through this before.

Thanks

9 replies

by cosloot

nescobar,

Even though it is a legacy problem. You should let Windows 98 SE find the modem in the peripheral setup mode. Unistall the modem in dos and then shut off computer and reboot boot. If the computer dos not find the modem in the boot upprocess and start the wizard then go to control process and then start the add new hardware wizard in the control panel.

Cosloot

by crosbywa

nescorbar,

I had the same problem with my modem I fixxed it by removeding the mode changng it to a "isa slot diffent if you have one if not, reboot the system with out it rind the drivers for it delete them and then reinstal the mode and drivers under windows

Hope it helps`

by sindian

this sounds to me like the dos legacy program isn't truley compatiable with windows. I deal with many dos programs every day and some of them have to dial out to transmit data at the end of the day. 99% of the time they will not work on NT machines unless the app teams plays with it until it does but htey prefer not to. With Win 98 there usuall isnt a problem but when it does interfer i just reinstall the dos legacy program and it seems to work fine. Good luck it is always tricky getting old legacy programs to function properly in Windows

by shanghai sam

Unfortunately you have 3 crummy options, each progressively more unlikely:
1)Run the DOS program entirely in DOS mode.
You can change the program to go into DOS from properties-advanced properties; however, this will cause Win98 to restart in DOS mode.
2)Find a win9x comm program and try to tweak the DOS program to use it to do the data transfer
3)Upgrade from the DOS program to At least a win3.1 version
You see, Win98 Dialer works because it is using a TAPI compliant driver. The DOS program is using it's own 16bit realmode driver and 98 will not allow it to access the comm ports.

This discussion is closed to new replies.