Discussion Locked

Windows98 Return codes

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Does anybody out the know anything about the ambiguos Windows98 Error Return codes, besides Bill Gates?

3 replies

by scally

There are 33 error codes which can arise in Device Manager, so this will be a long answer !

Code 1
This device is not configured correctly.

Solution button: Update Driver
This code means that the system has not had a chance to configure thedevice. To resolve the problem, follow the instructions in the Device Status box. In addition, you may be able to resolve this issue by removing the device in Device Manager, and then running the Add New Hardware wizard from Control Panel.
Code 2Depending on which device is failing, you may see either of two different messages. This code means that the device loader (DevLoader) did not load a device. When this device is a Root Bus DevLoader (for example, ISAPNP, PCI, or BIOS), the followingmessage is displayed

Windows could not load the driver for this device because the computer is reporting two "type" bus types. (Code 2)
Contact your computer manufacturer to get an updated BIOS for your computer.

where "type" is ISAPNP, PCI, BIOS, EISA, or ACPI.
Solution button: None
When the device is not a root bus DevLoader, the following message is displayed

The "type" device loader(s) for this device could not load the device driver. (Code 2)
To fix this, click Update Driver to update the device driver.

where "type" is the DevLoader such as FLOP, ESDI, SCSI, and so on.
Solution button: Update Driver

In addition to following the recommended solution, try removing the device from Device Manager, and then running the Add New Hardware wizard.

Code 3
The driver for this device may be bad, or your system may be running low on memory or other resources. (Code 3)

Solution button: Update Driver

As an alternative, use Device Manager to remove the device and then run the Add New Hardware tool in Control Panel.

Code 4
This device is not working properly because one of its drivers may be bad, or your registry may be bad. (Code

by sagittary

After I posted this question, I decided to go to Microsoft's website (something that I was just too lazy to do), and of course, after sorting through a whole lot of information that I was not looking for, found exactly what I was looking for.However, Scally, I thank you for your very quick response, even though your answer was not exactly what I was looking for.

The format of the return codes that I was looking for was :0x00000000, which I did find at Microsoft.

But, again thank you.

sagittary1@home.com

This discussion is closed to new replies.