Discussion Locked

Windows98 Wont Keep Time

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
The user bought this machine a year ago and since about a month after he bought it, it won't keep the correct time. The regional settings are correct but each time the machine is rebooted it keeps the date of the last time it was set and the time also starts from that point. So, if I set the time and date tomorrow then shutdown the machine and turned it back on a week from now, the time and date showing would be the same as when I shutdown.

9 replies

by dawsopolis

Change out the BIOS battery, or perhaps check in the bios itself to see if their may be some unknown setting turned on/off.

Sounds like a bad BIOS battery, but usually you will get an error message when this happens.

by superbee

You need to replace your motherboard battery. But take caution when replacing by grounding yourself from any static electricity. Use a grounded wrist strap or discharge static electricity by touching the bare metal of the system chassis once you have the case open.
Hope this helps you.

by gatesiam

Idallis,

Have you looked at the COMS Battery as the possible cause? It will be a flat, round, silver disk on the motherboard. Power the system down, ground yourself by touching the computer?s metal frame, and pop out the battery. Note the exact number and type, i.e. -"lithium", or take it with you to purchase a replacement ($3-5.00).

Good Luck,

Gatesiam

by paul d. masley

I believe that this is going to be a tough answer for your user to swallow. A computer system basically has two clocks. The battery powers the cmos and if memory serves me correctly (a+ class), the internal clock runs from atomic frequency (too deep to get into here). Both clocks depend on each other to keep the system at correct time. Your cmos clock appears to be working as the regional settings stays correct, but since is cannot count the ticks from the atomic clock, therefore when the unit is turned off, it stops counting time. Carefully look across the front and back of the motherboard for anything that looks suspicious like scratches, thrown solder, a loose connection, broken tower, cracks, ect. I suspect that even if you replace the battery, the result will be the same. Probally better set the user up for a new motherboard.

Paul.

This discussion is closed to new replies.