Discussion Locked

connecting 2 printers locally to a pc

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I want to connect an Epson LQ2180 and a HP 1100A printers to an IBM Netvista PC locally without using a manual data switch.
The PC has 2-USB, 1-SERIAL,1-PARALLEL PORTS and 2free PCI bus slots.

Some electronics data switch tried has not worked.
The two printers have provisions only for parrallel port connections.
The two printers are to be used to print 2 different documents generated simultaneously
from a business application running on the PC.
The PC Operator is not to be bothered selecting which printer prints which documents after each of the printer has been installed on the PC and given the recommended name recognised by the application.
Thank you.

7 replies

by jwilczyn

If you can use only a parrallel port and no external switches, then buy a parrallel card, install it as LPT2 into your PC and attach/install 2nd printer to this port.

by tony.colgrove

You best solution is to buy a USB to parallel printer cable. Now you can utilize those USB ports and not waste money on an additional "legacy" parrallel port that you will never use for anything ever again.
Connect one printer up to parrallel the other to the USB, or get USB for both and ditch parrallel all together.

by jwpluto

Don't recommend the second answer, unless you're fairly hardware knowledgable. The forst answer, adding a second PCI parallel port card is a simple solution. Cost is about $40 plus installation if you don't do it yourself. I have it and it works perfectly.

There are about three companies that make automatic electronic switching, which will print to one printer, then go to the other immediately after. But because they support Laser printers, they're expensive. Laser printers should never be put on manual (mechanical type) switches. The mfg will void the warranty if you try to use one and it causes a failure on the printer logic board. The mechanical switches create a small low voltage arc when changing the switch that can damage the electronics in the printer.

This discussion is closed to new replies.