Question Locked

160gb hardrive only shows 31gb

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a 160gb diamondmax plus 9 ata/133hdd harddrive.
I connected to a Bytecc usb 2.0 drive mate
It only showed 31GB and was not formated
so I formated it, wiped it, killdisked it, fdisked it, reformated it several times.
each time it stll showed the same 31GB

I have done this to 5 other large drivs both smaller and same size as it with no trouble.

so any other ideas of what to do?

6 replies

by ic-it

on the drive. It sounds like it is set wrong, insure it is set to master.

by oh smeg

Have a Jumper setting to limit the Drive Size to 31 GIG.

It really sounds as if it is incorrectly jumpered. Remove it from the case and reset the jumper and carefully look at the Legend on how the Jumper should be set I think you are looking at it back the front. ;)

Col

by vincenzoai

The first thing to check to compare the jumper position with the label on the hdd showing where 'master' 'slave' 'cable select' and '32Gb clip' positions are. My guess is that the jumper is in the 32Gb position. Have you tried partitioning the drive into more than 1 partition?

=edit= my apologies. I didn't see the previous posts.

by jmclellan

make sure you select NTFS as the format, not FAT or FAT32.

by snuffy09

check the diagram on your HD. there is a way to set the jumper to only use 32GB of HD space. on my seagate you just remove the jumper to correct the issue (using it as a USB extrnal)

This discussion is closed to new replies.