Discussion Locked

160GIGHD HIDES DATA OVER 128GIGS WINXP

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

160GIG HD HIDES DATA OVER 128 GIGS

USING XP PRO, MAXTOR 160GIG HD (NOT OS HD), MAXTOR 80GIG HD (OS DRIVE), EPOX 8K9A2+ MOBO, ATA 133, OCZ PC 3000 256MB DDR, AMD XP 2600 333 FSB CPU, ON HIGHPOINT RAID. NOT USING RAID ARRAY.

FORMATTED DRIVE AT 152GIGS AFTER COPYING 139 GIGS TO DRIVE TRIED TO VIEW FOLDERS. BUT ANYFOLDER PUT ON DISC AFTER 128GIG MARK IS INVISIBLE. IT IS STILL THERE BUT NOT VIEWABLE.
I CAN STILL COPY INVISIBLE DATA TO ANOTHER DRIVE BUT WINDOWS WILL NOT SHOW IT. ALSO DRIVE PROPERTIES READS 152GIGS FOR DRIVE BUT 128 USABLE SIZE. ANY IDEAS?

2 replies

by ismail_ngr

The 128/137GB barrier:

This ?barrier? is a characteristic of the original ATA (IDE hard drive)
interface. Therefore, fully overcoming the limitation requires special support
in the hard drive, system BIOS, and operating system.

The industry standard ATA/ATAPI specification defines the ATA (IDE hard drive)
interface. This interface definition includes a set of registers that is used
to specify various commands to the drive. Until recently, only 28-bits were
available for specifying the address on the drive for read and write
operations. This limited the maximum accessible capacity to 2^28 sectors or
512 * 2^28 = 137,438,953,500 bytes.

Microsoft considers 1 GB = 2^30, so they consider this boundary to be 128 GB.
The hard-drive industry considers 1 GB = 10^9, so they consider this boundary
to be 137 GB.

Revision 6 of the ATA/ATAPI specification has now defined a method for
accessing sectors beyond this boundary. The new hard drive interfacing scheme
uses 48 bits for addressing. This will permit full access to drives with
capacities up to 144 hard-drive Petabytes, or 128 Microsoft Petabytes.

By necessity, any hard drive that advertises a useful capacity greater than 137
GB must support 48-bit addressing.Microsoft Windows 2000 Service Pack 3 and
Microsoft Windows XP Service Pack 1 support 48-bit addressing.

If a hard drive larger than 137 GB is attached to system with a BIOS and
operating system that do not support 48-bit addressing, only the first 137 GB
(128 GB under Windows) will be visible to the system.

If the system BIOS does not support 48-bit addressing, a 48-bit-enabled
operating system should not be used with a hard drive larger than 137 GB. This
is dangerous because the operating system installation program may place boot
files in regions on the hard drive that are inaccessible to the
non-48-bit-enabled system BIOS. This could result in a system h

This discussion is closed to new replies.